20 Most Recent 2001 Dodge Neon Questions & Answers

Please check the link https://www.youtube.com/watch?v=2bjoheVvk2k

fuses blowing that fast almost has to be a shorted positive wire. have you traced your wires to see if any have been compromised or maybe wore against the frame. it could also be a wire on the inside lights .. the door switches for inside lights used to be notorious for shorting out over time and causing this issue

i used a test light to test each wire with lo beams on only 1 wire caused the test light to light up then when i turned on the hi beam the other wire lit up the yest light and the 3rd wire was just a common ground

It's either under the hood on the left hand sidein a black box on the shock tower or for the smaller fuses it's inside the drivers door lower end of the dash behind a pull off panel marked fuses

If it has a sun roof, it is normally from a blocked drain. Normally, they run behind the plastic molding of the windshield pillars.Also check for holes in the floor pan under the pedals, and heater core (as suggested by Dan, I forgot that one).

NO, IT IS A 2001
WHAT THEY MEAN IS YOU ARE LOOKING FOR THE O.E.M. PART # THAT STARTS WITH 529 AND THEN THE LAST 2 DIGITS SHOULD BE: -AD or -AF or -AF or -AK
THATS THE INFO THEY NEED!!
:-)

The key switch may be drilled out but the ignition switch may not be ingageing the power it needs for the electrical system ,replace the key cylinder .

Try starting it with the car in neutral not park.

You need to have a shop look at this, it is really hard to say what is wrong, just to big of a guess.

Fix your car right away by clicking the link I attached 2001 Dodge Neon Service Repair Manual INSTANT DOWNLOAD

don't waste your money and time just go to the link given and relax http://toolsnyou.com

have the fault codes read computers do not lie --they report what they know as fact

It should but please contact a local auto salvage yard, they have software that shows interchangeability of all parts.

Maybe something wrong with multifunction switch? Your lower stop lamps are wired through the multifunction switch, the high mount stop lamp isn't wired that way. The lower brake lamps and turn signal, use the same bulb filament, just not at the same time. Sometimes, you can click on diagram to enlarge, if not, click on your highlighted post, sometimes on that page, you can enlarge.

Speed odometer repair 2000 Dodge neonES

You don't do an ohm check . Hook a test light to battery positive an have someone crank the engine over an touch the point part of test light to the PCM circuit at the relay socket . If the test light light's the PCM is grounding the circuit . Watch this video ! Fuel Pump Electrical Circuits Description and Operation ASD relay chrysler