20 Most Recent
2001 Chevrolet Silverado 1500 - Page 4 Questions & Answers
How to set timing for blue print s/b 396
If the engine has been blue printed with different pistons and cam the best way to set the engine time is to loosen the dist so you can turn it and then start the truck and move the dist to the rear until the engine misses or slows and then move the dist forward until the engine smooth's out and runs smooth. Once this is done quickly step on the gas and the engine should respond right now with no hesitation. You can also use this method for a regular engine timing setting.
Will a 1997 4l60e work in a 2001
There are so many factors involved - bell housing bolt pattern, engine type, etc.
you are better to get a trans out of the same configured vehicle.
Show me where the orifice tube located
Same post again? Look at two AC pipes entering heater box. One is low side (large) and one is high side (smaller). Disconnect the high side pipe union and inside the pie going into heater box is the orifice tube.
2001 Chevy Silverado c1500 pickup has very low oil
Do not drive the truck until the issue is resolved.
1. Make sure the oil is at the proper level in the engine with the correct spec oil for the pickup. Oh it is normal for the oil pressure to be a little low at idle and go up to the normal range as the engine rpm goes up to normal operating range.
2. It could be either a real problem or a problem with the oil pressure indicator. To verify which connect a mechanical test pressure gauge of the proper range say a 0-100 psig scale to the point where the oil pressure sensor is connected. After it is connected test run the engine for a short period. If the pressure shows normal replace the oil pressure sensor. If the gauge confirms the low oil pressure then you have a serious issue in the engine. It could be:
1. Bad oil pump or oil pressure relief valve
2. excessive clearance in the bearings due to high miles.
2001 chevy silverado won't start when warm
Possible weak spark from ignition coil or low fuel pressure due to weak pump. Try spraying carb clean into intake throttle body when problem is present. If vehicle will start and run with a little spray then fuel pump is failing.
Process to change fuel pump on 2001 chevy silverado 1500
take the six bed bolt loose and then take three buddies slide the bed back put in the new pump slide it back n place and put the bed bolts back in. if u drop the tank u can easily break the hard plastis lines that go to the fuel tank. u only have to take the fill lines and taillight wires loose this way its alot quicker, and easier.
Not finding what you are looking for?