20 Most Recent
1995 Ford Windstar Questions & Answers
1995 Ford Windstar. the Dash, wipers, windows, went out, replaced GEM module and still won't work. How do I fix it?
If replacing the GEM module did not fix the issue, the next step is to check the wiring and connections to the GEM module. Make sure all of the wires are properly connected, and check for any signs of corrosion or damage. You may also want to try resetting the GEM module by disconnecting the battery for a few minutes and then reconnecting it. If none of these steps work, then the problem may lie in the fuse box or wiring harness, and you may need to take the vehicle to a qualified technician to have it checked.
11/23/2023 11:16:09 AM •
1995 Ford...
•
Answered
on Nov 23, 2023
What size socket does it take to remove a nut on a 95 Ford Windstar so I can change a wheel bearing
You should check out
www.reliable-store.com they have info on repair,
service, wiring diagram, electrical diagram, fuse diagram, troubleshooting, PCV, owner's/service/repair/parts manual, fault codes, error codes, etc everything on all vehicles. must check it out
3/21/2018 5:13:22 PM •
1995 Ford...
•
Answered
on Mar 21, 2018
I tried to check the
Make sure battery has a full charge. Use a digital multimeter across battery posts, everything off, what is the reading? The generic spec for a full charge is around 12.6 volts. Note the reading. Leave the leads touching the battery posts, have helper turn key to crank, how much does the reading drop? Usually it shouldn't drop below 9.6 volts or there about. If it drops to zero, try charging the battery. Check battery cables. Did you try jumper cables to see if it would crank?
1/29/2018 7:25:29 PM •
1995 Ford...
•
Answered
on Jan 29, 2018
95 ford windstar fuelmpump not pumping replaced it and still no start
Was the fuel pump new? When this much work is involved never use salvage parts. The fuel pump run function is interlocked with engine oil pressure sensor to indicate engine is running. On initial startup the fuel pump run is momentary to prime the injectors. Your problem is probably the oil pressure sensor or sending unit
6/15/2017 6:12:24 PM •
1995 Ford...
•
Answered
on Jun 15, 2017
Not finding what you are looking for?