20 Most Recent 1996 Ford Thunderbird LX - Page 6 Questions & Answers

check for spark at spark plugs, spray some carburator cleaner in the air filter housing then try to start the engine and watch oil pressure

tune up,fuel filter,air filter,clean throttle body.

Replaced automatic Control module in dash and module at blower and the blower Still have no heat. Original problem was smoke for vents and no blower help...1994 thunderbird

Here's a bleeder guide.You may need to bleed the ABS too.

You most likely have warped rotors. You can get them turned if there not to bad but if they are real bad then you'll need new ones

your rotors are warped

1. Access the COMBINATION Turn Signal and Hazard INDICATOR FLASHER on the Left-Hand (drivers) side of the instrument panel in the fuse junction panel.
   

1. Remove turn signal flasher/hazard indicator flasher by pulling indicator flasher straight out.
   

1. To install, align the terminals of the flasher and press into place.
   

How about a picture--

get a used transmission from a wrecking yard and just replace the whole thing.
a transmission kit means you need to open the transmission up. this has hundrends of moving parts, do you realy know how to overhaul it?

It is your e-brake cable. e-brakes are mechanical, not hydraulic, therefore it has nothing to do with your master cylinder. adjust the cable at the e-brake itself or re-hang the cable to its rightful resting place.

Ford products have a safety switch called an Inertia switch and it cuts the power off from going to the fuel pump. It is resettable with the push of a button on the switch.The location of this switch varies even year to year. If you have an air suspension, they like to mount the 2 switches close together. Both would probably be in the trunk.The other locations are behind the foot kick panels above the floor carpet or under the dash behind and below the glovebox.You can go online and search the statement: 1996 thunderbird Inertia switch location.They are meant to work by disengaging in a crash. A bump, trunklid slam, doorslam can activate it. If it activates once it does not mean it is defective or prone to do it again. The right vibration will trigger it.Please rate my info.

check that you have a thermal switch to switch on the fan and not a temp sender unit. One completes the curcuit when a set temp is reached ,the other is a resistance unit that lowers the voltage which in turn reads hotter on the gauge.