20 Most Recent 2004 Dodge Dakota Questions & Answers

There should be a screw attaching in up there either under a little tab or under the headliner. The tab can sometimes be a little hidden

2004 Dodge... | Answered on Jan 21, 2019

It could be the the wheel bearing...again, as you said. I also would like to know if you had the front end aligned when you changed the wheel bearing. If the tires have excessive wear on the outside or inside tread, you are out of alignment and BOTH wheel bearings need to be changed! It could also be the brakes wearing thin...check it out!

2004 Dodge... | Answered on Jun 29, 2018

That loud pop is the vacuum door moving closed. These trucks were well known for issues with not having enough vacuum to operate the heat doors (especially while driving up a grade). An after-market vacuum pump is the way to go. Disconnect the vacuum hose from the engine and install an electric vacuum pump to run all the controls. While you are at it, hook the vacuum hose, that goes down to the transfer case (4X4) to the vacuum pump, also.

2004 Dodge... | Answered on Dec 29, 2017

replace the resistor that should fix it

2004 Dodge... | Answered on Dec 11, 2017

If the crank sensor fails it will probably stop the engine. I have known a diesel engine continue running with a failed crank sensor but it was virtually undriveable and sounded really rough.

Pumping the loud pedal isn't likely to be very helpful whatever is wrong. Pedal pumping is for older cars with a carburettor that isn't in good order.

The best help will be from a guy with a scanner...

2004 Dodge... | Answered on Sep 17, 2017

Check the bulbs for continuity, the bulb holders for internal corrosion and the connections themselves for integrity.

2004 Dodge... | Answered on Sep 02, 2017

It sounds like you have a wire or wire bundle pinched somewhere causing an open or a short. As you just replaced the valve cover gaskets, check very closely in all areas that you worked on for the routing and proper security of wires and bundles.
Not that it makes any difference in your issue, but didn't the Dakota go to a 3.7L V6 in 2004 (as opposed to the 'old' 3.9L)?

2004 Dodge... | Answered on Jul 26, 2017

Brake Booster Gone?

2004 Dodge... | Answered on Apr 13, 2017

The oil sending unit is next to the oil filter, please take time to visit my auto-repair-website at: http://www.bigasautorepair.com/

2004 Dodge... | Answered on Jan 17, 2017

you need diagnostics scanner to read the engine light for the code, this will then indicate what problem is.

2004 Dodge... | Answered on Dec 29, 2016

blower motor resistor

2004 Dodge... | Answered on Dec 29, 2016

What is your question or problem ?

2004 Dodge... | Answered on Dec 18, 2016

What are you trying to reset? There are no switches to reset. If it got overheated, there is a reason. Expensive engine damage can occur if you try to drive it without identifying the cause of the overheat.

2004 Dodge... | Answered on Dec 14, 2016

Not finding what you are looking for?
2004 Dodge Dakota Logo

731 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2001 Dodge Dakota
2001 Dodge Dakota

995 Questions

1998 Dodge Dakota
1998 Dodge Dakota

851 Questions

1997 Dodge Dakota
1997 Dodge Dakota

695 Questions

1995 Dodge Dakota
1995 Dodge Dakota

711 Questions

1992 Dodge Dakota
1992 Dodge Dakota

605 Questions

Top Dodge Experts


Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Dakota Dodge

  • Dakota Dodge

Most Popular Question

2004 dakota codes p0052 p0732 p0720

  • Cars & Trucks