20 Most Recent
1994 Volkswagen Jetta Questions & Answers
How do you set the timing of a vw jetta 3
Get no.1 piston at tdc(top dead center)with cam at firing no.1 piston.fit your cam belt.and check your timming marks.Crank pulley marks and cam pulley marks.If you tell me what motor you have in there i can give you more details
Wont start, gives error code IN 02 on dash
I had the same problem with my 94 jetta, I would also have the alarm turn on as I connected the battery, if you lower the fuse box being careful not to disconnect anything, there is a box to the upper driver-side aria(that is if you are laying on your back looking up under the dash) this is the alarm control unit, there should be a white label on the wires indicating so (think it says alarm in German) theres a 6 pin(wire) connector and a 10 pin. unplug both connectors and look at the 6 pin connector. There is numbers where the wires are located on the connector, if you take a piece of wire and "bridge" wires 5 and 6 (The largest wires on the connector, red/red w/black stripe) your starter should work, any problem with the alarm system can cause the starter to be disabled. after bridging the wires or simply connecting them do not plug anything back into the alarm box, after this you standard vehicle alarm will be disabled permanently, but you will be able to start your car. If this dose not fix the problem you may have a defective starter, hope this helps.
Ignition switch
Need to disconnect battery, then remove airbag, the steering wheel (mark before removal), then remove top and bottom sheering column covers, then the spiral spring. At this point you will have access to the housing where the ignition switch is mounted. there is a breakaway bolt that secures this to the steering wheel. Can use an air hammer and gently loosen. Then you disconnect the harnesses from behind. Continue by sliding the housing off and then you will have access to the screw that secures ignition switch in place.
Install is the reverse.
I have a 94 jetta
Always power a stereo device off of a fused accessory circuit at the fuse block. Never tap into a harness or wires under the dash
'94 jetta3 gls will not go into park.
Have a mechanic check the shift linkage. On a car that old, it is probably worn or in need of lubrication. This is a SERIOUS safety issue, so don't delay in getting it checked and repaired!
My 1994 jetta has several issues i think it is a bad ground>
Ohms meter track it down or go see if a forum has your answer just might be a glitch others have had to but get yava readers digest at Lowe's shows yu howvto use a ohms meter properly picture by picture if yu don't know how that readers digest how to fix anything and I mean anything in your house garage whatever well written book really useful I'm telling yu best 20 bucks yu will ever spend
Not finding what you are looking for?