20 Most Recent 1994 Volkswagen Corrado Questions & Answers

I have the same problem on my Caddy /07. Switch only works on #4. Seems they should have supplied switches without faults. Any one know how to remove the dash switch?

Dont listen to that guy, Your car is not a diesel, and oil should be changed every 3000 miles, Diesel oil is way to thick

I have a Jetta VR6 with 111k on it and i use, Castrol Syntec 10w30

try a new petrol filter try servising it

are you keeping your foot in the same position while shifting or are you letting completely off the gas? get new shoes recently?

Try using a carb cleaner or fuel treatment for a carb car only not fuel injected. Is it fuel injected? check first does help. Make sure the oil level is right and tyre pressure should be around 28-30 psi per tyre.

1) use the correct viscosity oil

2) Is the oil dipstick looks OEM. It may be a universal replacement.

Next time when you do oil change + filter. use the right amount of oil and check is where the dipstick read,

Stick with that level as FULL.

i recomend to go to your local auto parts store and buy rebuild calipers . not much more money than the rebuild kits and they have a warranty.

Maybe a stupid suggestion, but check the oil amount in the gearbox. It must be done with the motor running. I did´nt know that and checked it motor off when the level on the dipstick was fine. When I checked it motor running it was too low. I filled it up and the gearbox works fine...

Could be a problem with the reader coil for your transponder immobiliser. The Corrado's ignition key has a transponder chip inside it which is matched to the ECU. There is a small coil inside the ignition which reads the code from the key. These quite often go faulty.
You can find further info on the Corrado Form. www.the-corrado.net

The wiper motors may be shot, also check the fuse for the wipers!

POS EIDES OTI TA MPEK PSEKAZOYN SINEXIA?? POY PIGE O EGEFALOS GIA ELEGXO???POS EPISKEYASTIKE I KALODIOSI???

check the fuse you may have to replace the brake light switch.

if your like is staying on it may mean the brakes are sticking and if thats not the case your sensor could be loose so whenever you apply the brakes its reading it as your slamming on the brakes.