20 Most Recent
Questions & Answers
2005 pontiac aztek cigarette lighter fuse... which one is it?
It is located in the fuse panel under the hood of the vehicle in the engine compartment. It's been a long time since I have worked on one but believe it's in the rear on the right (passenger) side of the vehicle but don't quote me on that. In any case below is a picture of the fuse layout and I marked the fuse (# 32) that control power to power ports in the front not the aux port in back. It should be a 20 amp fuse. Hope this helps....
on Nov 15, 2019
I have a Pontiac Aztek. I'm trying to get the
Underneith the steering column,ther are two /four bolts you have to remove to drop steering column.Block wheels and use emergency brake.If there is an indicator for park ,nutral and so on,then don't brake the cable going to that.It is clipped on the column housing that moves with the gear shift,push it off,then lower the column.
on Jul 05, 2018
How to replace brake booster on 2005 Pontiac aztek
Step 1 - Locate the Brake Booster
The brake booster is located adjacent to the master cylinder. There will be 4 mounting screws protruding through the booster. The booster is also attached to the brake pedal in the interior of the car. This is where you will start work in replacing the brake booster.
Step 2 - Remove the Brake Booster
Start by locating the booster rod that goes through the firewall and is attached to the brake pedal on the interior of the car. Typically, there is a cotter pin that secures the rod to the pedal, but there may also be nuts. When removing any fasteners in the course of this job, make sure to retain the nuts, cotter pins, and various other fasteners as the new brake booster will not come with replacement fasteners.
Remove the fasteners, whether it is a cotter pin or nuts. Slide the rod off the brake pedal. Disconnect the vacuum brake line that connects to the booster. In the engine compartment, there are four bolts securing the booster to the master cylinder and firewall. Loosen and remove these nuts. Remove the nuts (there are usually 2 in addition to the 4 that have already been removed) that secure the brake booster to the master cylinder. Wiggle the brake booster away from the master cylinder. There is a seal between the two. You will need to keep this as the new part does not generally come with another one. Remove the brake booster.
Step 3 - Install the New Brake Booster
Set the new brake booster on the four mounting screws. Tighten the nuts on the bolts to the master cylinder. Insert the push rod through the firewall. Start these by hand so that the threads are not ruined. Reattach the vacuum hose, then the nuts to the 4 mounting screws. Reattach the push rod to the brake pedal by whatever means it was originally secured with, whether by cotter pin or by bolts.
Step 4 - Bleed the Brakes
You will need to bleed the brakes after replacing the brake booster
on Jul 15, 2016
Not finding what you are looking for?