2000 Chevrolet Venture - Answered Questions & Fixed issues
Engine wont crank
im looking at that circuit , on the start relay on your radiator support , red is always hot via fusible link , purple to solenoid as you say , orange/black wire should be hot in run or start mode , if it is not the fuse for that wire is PCM/ABS 10 amp located fuse block in driver door jam , it does go through the nuetral saftey switch , the yellow wire going to the PCM must ground that relay to activate start mode . last note there is a PCM/CRANK fuse in the driver door jam also , 10 amp , if all this is good i would like to hear more . 1 more note about the nuetral saftey switch is the pink wire going in and the orange/black wire coming out should have continuity in park and nuetral ....let us know thanks
Where is the air conditioner clutch relay?
It's in the under hood fuse box. Hopefully the fuse box has a legend on it that will tell you which relay is which? Your owners manual may have this info? Some owners manuals you can look at online for free. Notice ac clutch relay in diagram.
4cyl. Where is O2 sensor?
Good Morning Gary, would love to get a little more information from you. This vehicle actually has two sensors in the exhaust that deal with Oxygen and fuel to help the engine run correctly. The one you are probably asking about is on the exhaust about 6-12 inches from the exhaust manifold. It should have 4 wires running to it and be screwed into a threaded port on the exhaust pipe. This sensor is called sensor 1.
2000 chevy venture. key fob
The button is not working. It's programmed if the other functions (buttons) work. What you can do is take it apart, clean the rubber part (the buttons) with soap and warm water. Then, use a cotton swab and rubbing alcohol to clean the circuit board where the back of the buttons contact the board.
I have a Saab 93 2002 Turbo 2lt with a low oil
the first thing to do is to have the oil pressure read using a mechanical gauge
that ensures that you know that the engine is running with the right oil pressure
you can test the ECM operation by using a substitute ECM that is a known good unit
run the fault codes to see in the oil pressure sensor is a problem
At this point , test the oil pressure as suggested then change the oil pressure sensor
Why do I not have any lights inside my 2000 venture
My guess is a fuse in the fuse panel at the far passenger side of the dash,you have to open the passenger door to check it or ....is the interior light over ride switch above the rear view mirror in the correct position for interior lighting?
Not finding what you are looking for?