20 Most Recent 1995 Chevrolet Cavalier Questions & Answers

Sometimes can take a hammer and jar the shoes loose by hitting the backing plate where the shoes ride and free up that way

Take your car in to have your check engine light code read. Most car parts dealers will do this for free. A possibility is you speed sensor on your transmission is going out.

Given the age of the vehicle, Chevy does not have to stock or make those parts any longer. (10 years is the max required by law.) You are going to end up using aftermarket parts. I can guarantee that if you take it to any exhaust muffler shop, they are just going to cut the pipes with a saws-all.

Did you clean or scuff up new battery terminals and wire ends? Sounds like a bad or missing ground strap.

Use a gage and check proper fuel pressure, 41--47 psi, key on engine off. Cycling the key on and off a few times before you crank it, should prime the system. Check for fuel injector pulse, use a noid lite, engine cranking. The voltage for fuel injector probably goes hot with the key on. The computer grounds the fuel injector circuit. The diagram is for 2.2L engine. The pink wire for fuel injectors is voltage, the bottom wire is ground. We've talked about the fuel system, could be other issues?

The first step would be to take it an have a diagnostic scan tool hooked up , Don't worry about back up modes . From the sound of it you know very little about ODB 2 an computer control emissions . Your not going to learn anything from a chiltons manual ! Your best bet , take it to a qualified repair shop . I have over thrity years in the automotive repair business an i can tell by your post that you will never be able to repair this , so do yourself a favor an take it to a professional

you need a new fan switch

http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?pageId=0900c1528003d007Your fusible link could be burnt and not getting a good connection,follow all wiring tied into positive battery cable for burnt or swollen wires.Click on link.

what type of alarm system do you have is it factory came with car

The intake is on you muffler. The oxigen sensor is on section from the motor to the

Starter relay/starter start w those checking for power and u can staright wire to check starter itself

It may just be the switch. The wiper motor is usually under the cowl at the bottom of the windshield. I'd guess the switch is probably wore out so it wont shut off.

what makes you think that's your issue?

Here's a link to your wiper motor. Repair Guides Windshield Wipers And Washers Windshield Wiper Motor...

It is under the wiper blades. Remove the blade arms, remove the plastic bezel, remove the motor.

Replace the wiper motor. The park position is built into it.

I think what your looking for is the wiper relay

Pull the Fuse. Otherwise you have to take the steering column apart in most cases

Most of the time it is in the wiper transmission in side of wiper moter. thats where the parking cam is. Spray pb blaster or similar on motor shaft and linkage it may help. Fix the problem, if not replace the motor. You may be able to pick up a used motor at a junk yard to save $$$$. Good-Day!

Need to get new wipers. Sounds like they may be old. Also try to lubricate arm where it is connected. It might be corroded in the spot where it stops just enough to make it Stop.