20 Most Recent
1994 Mazda 2WD B Series Pickup Questions & Answers
Wiring on map sensor
Some of those models had a MAP Sensor and some didn't.The mazda and the Ford ranger are the exact same truck with the exception of the grill and tail lights. I am not sure if your saying that you have a map sensor and no wire or a wire and not map sensor.If there is no wire for a map sensor then you truck does not require one. If it has the wire then you will have to get a map sensor.The trucks that don't have a map sensor will have a Mass Air Flow Sensor, located at the top of the air filter box.
I hope this will help you.
Engine fan won't work
fuse for fan is probably in a box in the engine compartment. diagram usually inside on lid
Turck runs and then shuts off after it warms up
I'm assuming it doesn't start right back up. All "crank, no start" conditions are approached in the same way. Every engine requires certain functions to be able to run. Some of these functions rely on specific components to work and some components are part of more than one function so it is important to see the whole picture to be able to conclude anything about what may have failed. Also, these functions can ONLY be tested during the failure. Any other time and they will simply test good because the problem isn't present at the moment.If you approach this in any other way, you are merely guessing and that only serves to replace unnecessary parts and wastes money.Every engine requires spark, fuel and compression to run. That's what we have to look for. These are the basics that need to be tested and will give us the info required to isolate a cause.1) Test for spark at the plug end of the wire using a spark tester. If none found, check for power supply on the + terminal of the coil with the key on.2) Test for injector pulse using a small bulb called a noid light. If none found, check for power supply at one side of the injector with the key on.3) Use a fuel pressure gauge to test for correct fuel pressure, also noticing if the pressure holds when key is shut off.4) If all of these things check good, then you would need to do a complete compression test.Once you have determined which of these functions has dropped out, you will know which system is having the problem.
Not finding what you are looking for?