20 Most Recent
1989 Mazda RX-7 Questions & Answers
Starting problems
Its possible that the pressure valve relay is bad, you can try that. I had to replace one last year because it was doing the thing your talking about. I hope this helps. Alvin
Where is the starter located
jack up the drivers side of the car, crawl under and look where the transmission bolts to the engine. you cant miss it :) it will have a big wire coming off of it ( power wire)
My 1991 rx7's clutch went
Fixing the clutch, I bet one of the lines had been leaking clutch fluid for quite a while. May top it off, and have a friend stomp down on the clutch to see if you can find the leak and repair it, then make sure to bleed your clutch back off. BTW, do you mean no compression as in the clutch has completely gone, or the engine has lost compression?
I have a 1989 mazda rx7 convertible automatic with
its not hard at all. as long as your good with your hands. and know the basics of your rx7. other then that everything bolts in. you just need a turbo driveshaft for sure. or they sell a custom driveshaft on mazdatrix.com so you can keep your N/A differential.
Mazda rx7 1989, when aclerate
I am assuming it's a standard. Your clutch and pressure plate are slipping. Check to see if the clutch can be adjusted , if not they have to be replaced
Starts in the moring wont start when its hot
The Starter is most likely the problem. The solenoid in the Starter doesn't work so well when it's worn out and gets hot. That's why the solenoid works better when cold. Changing the Starter out should solve the problem.
Leakin anitfeeze down by the spark plugs why?
I'm not very familiar with rotary engines but I'm pretty sure what you have is a gasket that needs to be replaced.
It is highly likely then that you are also burning it as well so don't run it until you change the gasket.
Not finding what you are looking for?