20 Most Recent
2001 Dodge Dakota - Page 9 Questions & Answers
Lights flicker
check ground locations in harness under hood ,make sure they are tight
Is there a switch to turn off passenger's control of window
The driver's door has a control panel with switches to control 2 or 4 windows, above those are two switches - the one closest to you is the power door lock and the one away is the window lock button. The image below has a red arrow pointing to the switch. Good luck!
Trouble code p1762
Code p1762 is the governor pressure offset volts too high or too low. This is a transmission solenoid that probably needs replaced. I believe that you have to take the pan off to get at it.
Oil pump replacment
Take the oil pan off, and it will be sitting there staring you in the face. Look at the replacement and see where the bolts are that hold the pump on. Remove them, take old pump out, put new one on. DO not overtighten the bolts. not a tough job, but very messy. Best to let the oil drain overnight after oil pan is removed. You will also need anew oil pan gasket
The lat sensor
on the intake should be gray in color 2 wire connector think driver side of pleanum close to top
How do you install a window regulator for a 2001 dodge dakota?
well first take off the door panel it shouldnt be hard remove plastic cover off door.Make sure your window is all the ways up before you remove the motor.you can hold it up with duct tape or anything similar.Then remove the screw that go to the regulator sometimes it has rivets wich have to be drilled off.The new regulator should come with screws if it has rivets if not u use the same old screws.Also unplug the harness of it . Install new one,screw it on and reverse the procedure.Any problems keep me posted
I would like to bypass the air compressor with a smaller belt
impossible to work out . check to see if there is a application that doesn't have the compressor in the system and get that belt ( good place to start is at your car spares department to see if such a belt is listed) Alternatively take a flexible tape measure and wrap it around the pulleys you want to use and read the distance . It will be a starting measurement and when you buy the belts ensure that you will be able to exchange the belt if it doesn't fit
Not finding what you are looking for?