2000 Dodge Durango - Answered Questions & Fixed issues
My 2000 Durango has no rad fan relay or trans relay or 02 #2 relay is that a bad thing or what are they even for? Also my truck shuts off when I press on gas at stop sign them won't turn on .
Are you sure? I do not see a O2 relay on my 2000 Durango 4X4 SLT but I know I have a rad fan relay as well as ( actually I will need to see for sure if I have a Tranny Relay or not, I know this post is a bit old but may help someone now that has similar issues. As far as dies when you gas it at a stop sign then will not start again?? could you elaborate as this is way to Vague to allow me to have any decent info to tell you and I hate it when people answer and seem to have only read 2 words out of a 100 word paragraph. Like asking where the fuel filter is located and how to properly and safely replace it and someone says Mechanic or goes on talking about the octane and fuel cap and nothing remotely about the OP ?? other then maybe the WORD Fuel.
11/19/2023 2:17:06 AM •
2000 Dodge...
•
Answered
on Nov 19, 2023
•
194 views
2000 Dodge Durango. WHAT DO I DO WHEN THE MECHANIC IS WRONG?
The tie rod ends should have a taper to them and likewise, the knuckle will have a taper to the hole the tie rod end goes into. As long as the tapers match, you are good. As far as driving without an alignment, if it feels secure when you drive, I wouldn't worry about it. You might get excess tire wear, but if you are only driving for a few days until the parts are in, you should be fine.
9/13/2023 6:27:56 PM •
2000 Dodge...
•
Answered
on Sep 13, 2023
•
433 views
Need diagram for firing order to a 2000 Dodge
I apologize for the late response...Due to the bad economic situation this site has had a substantial (+50%) increase in the number of questions being asked in the last four months.
For the 4.7L:
Firing Order:
1-8-4-3-6-5-7-2
Cylinders:
8----------7
6----------5
4----------3
2----------1
(Front of Vehicle)
Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.com!
12/23/2022 8:56:51 PM •
2000 Dodge...
•
Answered
on Dec 23, 2022
•
2,241 views
2000 Dodge durango wont start after driving for a while.
i had the same problem in a dodge ram pick up. ended up being the coil. when the coil got hot my truck would die or not start again until the engine had cooled down. replaced the coil, and whalaaaaah. no more trouble. good luck!!!!!!!!!!!!!!
10/10/2022 8:20:13 PM •
2000 Dodge...
•
Answered
on Oct 10, 2022
•
978 views
2000 dodge durango cooling issue: I HAVE THE 5.2L
Ihave a 2000 Dodge Durango i have put a new radiator and the gaskets came back good um i replaced the coolen fan also the thermostate and tested it it it came back good when i run it its fine but when i am in line its hot when i drive it cools down........
8/5/2022 1:04:20 AM •
2000 Dodge...
•
Answered
on Aug 05, 2022
•
491 views
2000 dodge durango no headlights all other lights
The diagram is for headlamps, The top wire to headlamps in diagram is voltage, fuse protected and hot all the time. On/off--hi/lo beams are controlled on the headlamp ground circuit, bottom wire coming from headlamps in diagram. The dimmer and headlamp switch are part of the headlamp ground circuit.
4/6/2019 3:28:02 PM •
2000 Dodge...
•
Answered
on Apr 06, 2019
•
1,488 views
2000 dodge durango will ot shift into park
hello
u'd need a proper manual for this in my opinion
like there are plenty of dealers and online shops that deal in those..
you can get some free at reliable-st ore and it;s actually really illustrative
2/19/2019 9:04:04 AM •
2000 Dodge...
•
Answered
on Feb 19, 2019
•
85 views
My 2000 Durango suddenly starts running rough.
First, check the injector connector for tightness and corrosion. Then check computer connectors and any in-between connectors. Take the car to one of the auto parts stores that have the free code-reader service. look for set codes, delete them and run the engine too see if the code comes back. If it does not, one at a time jiggle the injector connectors to see if one sets a code, likewise any other plugs you can reach, fuses and relays. If the store clerk does not want to go through this routine, buy a code reader, preferably one with the re-set feature. Many cars require you to drive 15 or so miles after clearing the codes before new ones can set. Good reason to have your own. It may take a few years for the code reader to pay for itself, but you'll probably be driving for a few years.Or, go back to a parts store after driving far enough to set new codes, if any.
Or spend bucks while repair shops change parts until the problem is corrected. I keep a code reader in my van since 1997, have not needed it yet with my 2009 g-caravan.
1/27/2019 6:16:27 PM •
2000 Dodge...
•
Answered
on Jan 27, 2019
•
711 views
Not finding what you are looking for?