2000 Mazda 626 - Answered Questions & Fixed issues
How to fix a busted hose on a 2000 mazda 626
The best solution you'll g et from books at
www.reliable-store.com
These are books containing info on repair, service, troubleshooting, parts info, assembling dissemble, removal, error/fault codes, wiring diagrams and everything on any vehicles cars, atv, trucks. forklifts, boats, excavators etc.
6/14/2018 2:47:51 PM •
2000 Mazda 626
•
Answered
on Jun 14, 2018
•
69 views
I just did a tune up on a 2000 mazda 626 with a V6. the parts changed were the plugs,ignition coil, plug wires, mass air flow censor, air filter, and fuel injector cleaner. the plugs were gapped at .3
9 times out of 10 your problem is going to to be with the MAF Sensor. You changed it, was the old one bad? If not try putting the old one back in. If you bought an aftermarket MAF and didn't replace with an OEM MAF, that could also be your problem. Recheck to make sure it's seated correctly, check the wire connection.
Unless the stickers have been removed, you should have a vacuum line diagram under your hood.
Here are what you should check from top to bottom.
- A clogged, stuck, or leaking fuel injector
- Faulty fuel regulator
- Dirty or faulty mass air flow sensor
- Faulty coolant temperature sensor
- Faulty thermostat
- ECM needs reprogramming
- Dirty or faulty oxygen sensor
- Vacuum leak
- Fuel delivery problem
- Incorrect fuel pressure
3/22/2017 1:41:31 PM •
2000 Mazda 626
•
Answered
on Mar 22, 2017
•
118 views
Check engine light
Not unusual. The CEL is there to tell you that the onboard computer has detected an anomaly (or more), and has stored a code in its memory to assist in determining the failure. You need an OBD-II code reader to retrieve the codes from the computer and take whatever corrective action is recommended based upon the code(s) found.
8/25/2016 10:36:53 PM •
2000 Mazda 626
•
Answered
on Aug 25, 2016
•
61 views
2000 Mazda 626
Sixteen year old car with only 40K miles must not be driven often, or sat for some time. I would suspect fuel system issue, such as bad pump, clogged filter, bad regulator or faulty injectors. Start by testing fuel pressure.
6/20/2016 7:06:19 PM •
2000 Mazda 626
•
Answered
on Jun 20, 2016
•
106 views
Starter spinning but not engaging
This can be caused by several issues: most common is starter bendix failing; next broken tooth on flywheel/flexplate; next weak battery; next starter bolts loose.
4/13/2016 3:53:00 PM •
2000 Mazda 626
•
Answered
on Apr 13, 2016
•
121 views
Not finding what you are looking for?