20 Most Recent
2005 Ford Focus - Page 8 Questions & Answers
Where is fuel rail pressure sensor located 2005 ford focus
Before you change your fuel pump or fuel rail pressure or the sensors there are five things you will have to check first....first the inertia switch second if you have had the fuel filter change third the fuses fourth the sensors if they are bad or have been wet and the fifth the fuel pump pressure...
What is the torque sequence for the cylinder head on a 2005 ford focus
Stick all the bolts in and run them down snug. Start at the center bolt and torque it half spec. Then do the same with the rest in a circle from center to the outside. Then torque them to full spec from center to outside in a circle. This is normal procedure if the sequence is not available. You could always google it if you don't trust this old timers suggestion.
I recently bought a 2005 ford focus sedan, I have
Replace the drivers side latch. It on the door jam. You have to remove the drivers side panel to get it out. Look for screws behind plastic plugs. Around the door handle and the arm rest. Sometimes around the perimeter of the door. then the panel will pop off. pop off the plastic mounts from the rods(look at them, you'll see how they come off). Three screws and two electrical plugs on the jam and pull the latch out
Reset Ford Focus Engine System Fault warning light
My 05 1.6 petrol Ghia is showing Engine System Fault. I parked it at home the other week and it wouldn't turn over. Have been out to check relays etc, changes coil pack, plugs and ht leads and now it doesn't do anything when trying to turn the engine over. Any advice would be helpful because I'm not mechanically/ electrically minded so haven't a clue. It had a new fuel pump fitted in April so I assume I can discount that?
Get the water pump out it's stuck
You are missing something....like a bolt you can't see. Count the number of bolt holes in the new pump and make sure you have removed that many bolts.
Undefined
On the thermostat housing which is located on the back side of the cylinder head above the transmission bell housing.
Not finding what you are looking for?