2000 Ford Focus - Page 3 - Answered Questions & Fixed issues
My key is stuck in the ignition of my 2000 ford focus
There is a hole in the plastic column cover on the bottom. This is the access to a spring loaded pin which keeps your keyswitch in the ignition hole. You may have a worn out key tumbler or the tumbler is loose in the housing and simply needs to be removed and reinserted to work again.
A drill bit or thin hex wrench needs to be poked into that mentioned bottom hole to release the tumbler from the housing with a gentle pull.
7/12/2017 11:28:32 AM •
2000 Ford Focus
•
Answered
on Jul 12, 2017
•
278 views
Wont start
Would you like to try an explain a little better ? If the engine doesn't spin when you turn the key to start ,what good would pouring fuel into the engine through the throttle plate? Plus if the engine does spin when turning the key to start why in heII would you bang on the starter ! I would say from your post you don't know a heII of a lot about cars ! Do yourself a favor an take it to a qualified repair shop before you hurt yourself .
7/2/2017 10:01:47 AM •
2000 Ford Focus
•
Answered
on Jul 02, 2017
•
140 views
1996 fiesta ghia diesal no glow plug light
No power to the glow plugs means no power to the light also. You have a bad fuse or connection to the glow plug relay. Fix that and your good to go. Has nothing to do with your indicator lights on either side of dash. Glow Plug power indicator is labeled THAT and only that.
6/25/2017 8:48:11 PM •
2000 Ford Focus
•
Answered
on Jun 25, 2017
•
176 views
Why does my air conditioner make my car stall?
If your A/C compressor clutch is binding or seized, - the extra load will slow down the engine as everything runs on 1 belt on this car - check your Freon level and refill or replace the clutch/compressor
5/25/2017 2:57:17 AM •
2000 Ford Focus
•
Answered
on May 25, 2017
•
453 views
2000 Ford Focus ZTS 2.0L
I read no place in the post that you have performed an OBD2 fault code test, you must do that test first, it is the key to fixing all electronically controlled engine issues like this
3/20/2017 11:06:18 PM •
2000 Ford Focus
•
Answered
on Mar 20, 2017
•
559 views
Rough idle/ not accelerating/coolant leak
https://www.bellperformance.com/blog/rough-running-engine
Apr 21, 2015 - When diagnosing an engine with a rough idle, there are certain things that must be ... If the problem does not reoccur, the codes will be erased by the computer. ... when accelerating the vehicle, which causes a higher fuel demand. .... it was water in gas...added added Gas LineAntifreeze/Water Remover.
3/17/2017 5:46:22 AM •
2000 Ford Focus
•
Answered
on Mar 17, 2017
•
279 views
Answer to my question
The fuse will blow because it is telling you there is a fault so just changing the fuse will not fix this.you have to find the scource of the problem eg wire shorting etc
10/15/2016 4:41:44 AM •
2000 Ford Focus
•
Answered
on Oct 15, 2016
•
158 views
What is engineering
the application of science and mathematics by which the properties of matter and the sources of energy in nature are made useful to people
8/2/2016 12:56:35 AM •
2000 Ford Focus
•
Answered
on Aug 02, 2016
•
108 views
Airbag light stays on
an airbag light, can mean a number of things. Your airbag will not deploy if a fault airbag light is on. It is dangerous, it has to be taken to a mechanic, to get it checked out. God-Bless! The airbag codes need to be checked to find the fault.
6/2/2016 9:43:57 PM •
2000 Ford Focus
•
Answered
on Jun 02, 2016
•
508 views
Not finding what you are looking for?