20 Most Recent
2003 Pontiac Sunfire - Page 9 Questions & Answers
Radiator leaking
Try to tighten,if that doesn't work,drain coolant and remove plug and take to auto parts store and ask them you need a replacement.
How to I jump start my starter
Hook a cable to the large post from a positive 12 volt source, then attach the ground cable to the body of the starter and then touch 12 volts positive to the post marked "S" where the purple wire was connected, this will engage the starter.
High beam headlights quit working. Bulbs are OK.
If your getting power at the headlight wire harness, then it's going to be the bulb it self, but make sure your checking the right 12 volt terminal at the plug. There should be three terminals there, there is a ground, 12 volt low beam, and a 12 volt high beam. If both the low and high 12 volts are getting power, then it's going to be the head light bulb it self that has reached the end of it's life time since the day time running lights are always on which is the high beams. Good luck and check the fuse box under the hood by the battery.
Changed filter
I would assume the fuel pump has failed. Get a fuel pressure test gaulge and check the pressure at the fuel supply rail near the injectors.
Installed ignition on 2003 sunfire, how do i reset security system
did you reuse the same pass lock sensor and key lock tumbler? if so the security system shouldn't have to be reset. if you replaced either lock cylinder or pass lock sensor then you have to turn the key to the start position and then to the run position and leave the key on for about ten minutes and wait for the security light to stop flashing. once the light stops flashing do the same process again. it may take up to three times to get the key code encrypted into the BCM. on the third time after the light stops flashing the car should start, if not then you may have another problem.
Not finding what you are looking for?