1994 Nissan Pickup - Page 5 - Answered Questions & Fixed issues
How to fix a door latch on a 1994 nissan pickup
I just joined 10 minutes ago.........I think I can help you.Use a spoon or wide screwdriver to pop the plastic rivets that hold the interior of the door on. Takes some courage as they dont come away easily, about 8 in all.1, Remove the window winders, by either pushing the "ring" that touches the interior till it stops and then slide the winder off the toothed stub.pop the cover off and use screwdriver/socket to remove winders.2, Use old eating knife or wide bladed screwdriver around edge if soft interior of door and pry/pop the hidden plastic rivets, releasing the soft interior away from the metal or the door.3, You may have to twist off the latch, just like a bottle cap.4, You will see the wire coat hanger type metal that connects to the latch and locking mechanism.If you have some grease with you you can also grease up the mechanisms for the lock, lock release, window, mirror. That's how it is on my Volkswagen.Good luck, Dave
4/2/2013 7:34:04 PM •
1994 Nissan...
•
Answered
on Apr 02, 2013
•
809 views
Where's the relay turn signal box at
Not sure of your engine size but the 4 and 6 cyliner should be the same. Now if you have an automatic or manual transmission does make a little bit of a difference. Below are the different locations. The top/first picture is the location of the flasher unit if you have an automatice transmission and the second second/bottom picture is the locaation if you have a manual transmission. Hope this helps....
3/28/2013 3:27:41 AM •
1994 Nissan...
•
Answered
on Mar 28, 2013
•
1,284 views
Starter relay
Its mounted on the right fender well. Here's
what it look's like.
3/25/2013 7:32:13 PM •
1994 Nissan...
•
Answered
on Mar 25, 2013
•
33 views
Jumps out of first gear
check your three mounts; if they're ok then it's most likely a trans. problem. by three mounts I mean the two engine mounts and the one under the tail of the trans.
3/13/2013 12:37:05 AM •
1994 Nissan...
•
Answered
on Mar 13, 2013
•
157 views
My brake lights will not engage when i press the brake pedal
fuse, relay, or bad connection. check the rubber plug between the switch and mount, they fall out and can cause lights not to work. Also check grey connection for rear lights under the bed of the truck. Sometimes gets loose or too dirty. There have also been dealer recalls for this problem, so google TSB 1994 nissan pickup and look around. hope this helps
12/11/2012 1:27:36 AM •
1994 Nissan...
•
Answered
on Dec 11, 2012
•
147 views
1994 nissan pickup 4x4 2400 where should the rotary point when at top dead center
Do you mean the distributor pick-up rotor? If it is and you are referring to the number 1 piston, the tip of the pick-up rotor should be a little bit pass the #1 contact terminal of the distributor cap. The tip should be exactly at the terminal when the piston is at the specified position before the top dead center (BTDC).
10/28/2012 1:58:13 AM •
1994 Nissan...
•
Answered
on Oct 28, 2012
•
307 views
Where is the thermostat
if you follow upper radiator hose to motor it should be at the end of hose at block of motor .
10/2/2012 3:34:04 PM •
1994 Nissan...
•
Answered
on Oct 02, 2012
•
57 views
Replace fuel pump
It should be on top of the fuel tank itself. You will have to drain your gas tank, remove the tank and then replace the pump and put it back together.
9/21/2012 2:16:52 AM •
1994 Nissan...
•
Answered
on Sep 21, 2012
•
136 views
Not finding what you are looking for?