20 Most Recent
1994 Nissan Pickup - Page 2 Questions & Answers
Replaced all brake lines no leaks but cant get it to stay up
Most likely causes: air in the front system or a bad master cylinder. Make sure the master cylinder is bled out at the output lines. Try clamping the 2 rubber lines to see if you get a normal pedal which would mean air in the caliper. Or if the pedal is still bad probably the master
1994 nissan pu starter drags when engine is warm, new starter,new battery. new timing chain & gear, valve job,head gasket
1. Make sure all the high-current battery and starter connections are clean and shiny. Don't just wipe them off; get one of those battery terminal cleaners that scrapes off the top layer of oxidation. Use a wire brush on connections the battery cleaner doesn't fit. Remove each connection, clean it and put it back.
2. Be sure the timing is set correctly.
3. If there was a heat shield on the starter, make sure it's still there.
4. Get the starting system checked at an auto parts store. Maybe you got a bad battery or starter.
How do I get the passenger side door open?
Try taking off the inner door panel, usually attached with Phillips screws. In most trucks, this will allow access to the locking and opening mechanism. Once this is exposed, it should be relatively simple to pull the latch open.
Why didn't Nissan airbag deploy?
Speed....point of impact.....all make a difference on when an airbag deploys it is possible to have an accident and the airbag will not deploy the sensors have to register an impact of certain size and weight to deploy .....in older cars you are probably glad they did not deploy because they often blacked eyes broke noses and caused Neck injury by the amount of force they deployed at..
\
1994 nissan pickup, runs rough. wont hardly run. cant find the problem.
It could be many different things. Check the vacuum lines. Check spark plugs. Check compression in engine, check fuel lines filter and injectors or carb. It's sounds like a misfire which can be caused by incorrect fuel, spark, or compression. And sometimes they run rough because vacuum pressure is incorrect or line is leaking. Start with the basics and go from there
Not finding what you are looking for?