20 Most Recent 1994 Nissan Pickup Questions & Answers


Your problem seems to be a faulty solenoid. The solenoid is a little monster that lives on top of the starter motor, and its job is twofold. Firstly, it supplies full battery power to the starter motor, and secondly it drives a gear on the starter to engage with the engine flywheel.
Now, your problem. The first guess could be the ignition switch, but fitting a toggle seems like a fairy tale answer. Check the starter solenoid to see if there is a frayed wire on the thin wire that connects to the starter, or possibly a frayed wire on the battery cable that is shorting to the small connector. Otherwise, I have seen the terminal of this small wire actually become loose and turn in the direction of the battery cable, which is also connected to the solenoid. A short here will cause the problem you are describing.
Finally, the solenoid could have a short circuit inside the body, which means replace the solenoid.

1994 Nissan... | Answered on Sep 29, 2018


I would start by checking the resistance of all of the injectors. I saw this happen last week, I had a new injector that was reading low ohms and it was making two cylinders misfire. Replace the new one with a another new one and both cylinder ran good. I dont know what the ohm value of your injectors should be but I would want at least 10 ohms, All of them will be about the same except the bad one..I did a web search on your problem and it was covered at several places.

1994 Nissan... | Answered on Apr 29, 2018


Check the battery cables. If it is the braided type it may look good but not connecting like it should, Try connecting another earth cable from the battery negative to the same point as the original. Make sure that the contact area is clean and finally check every point where cables contact to. It is important to work on these points with the battery removed, in order to avoid short circuits.

1994 Nissan... | Answered on Feb 03, 2018


Auto zone does free engine light code reads...Check em out.

1994 Nissan... | Answered on Dec 14, 2017


Hi Jon,I have a 85 nissan 720 4x4,you will need to jack up the motor to do the oil pan removal,it's a job,here's a link on how to do... Repair Guides Engine Mechanical Oil Pan AutoZone com

1994 Nissan... | Answered on Nov 15, 2017


Clean the battery post's and terminals and hot wires to starter and the ends of the ground wires. Try to jump start it if it starts it may be your battery or your starter is going bad.

1994 Nissan... | Answered on Aug 22, 2017


Could be your clutch slave cylinder is bad,check your clutch fluid,if real low or empty then it is bad,it's located on the side of the transmission with a hydraulic hose connected to it,I have a 85 Nissan 720 4x4 5- speed,had to replace mine a few times.Here's a link on how to do. Repair Guides Clutch Clutch Release Cylinder AutoZone com Here's another link. Repair Guides Clutch Clutch Master Cylinder AutoZone com Here's the new part. Duralast Clutch Slave Cylinder 12425 Read Reviews on Duralast 12425 Your master cylinder probably is good,I just had to change the slave cylinder on mine,unless your's is leaking.If you are in a bind you can add brake fluid,yes it uses brake fluid.Then bleed it then it will get you home,you can get a one man bleeder kit,I have one,here it is. OEM One man brake bleeder kit 25036 Read 17 Reviews on OEM 25036

1994 Nissan... | Answered on Jul 20, 2017


I just had a similar issue with my Colorado. It turned out to be the BCM(body control module). I don't think yours has one but the ECU might control the same systems. Check your fuses and if those are good look at your wiring diagram and what the common denominator is between those systems. My bet is it's the computer.

1994 Nissan... | Answered on Dec 13, 2016


Metal patches made from galvanized sheet metal, use a pop rivet gun to attach them

1994 Nissan... | Answered on Sep 19, 2016


Does it turn over, or don't turn over at all? If it does turn over, then my guess would be the control module. Because, when the module gets hot, it will not start until it cools off. If it does not turn over, then I would have to say the starter is bad. I sincerely hope that this helps you. Best wishes.

1994 Nissan... | Answered on May 01, 2016


charging or starting circuit?

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

1994 Nissan... | Answered on Nov 15, 2015


Remove the 4 #2 Phillips screws that hold the black plastic surround to the dash. They are located at the 4 corners. Remove the 4 other #2 phillips screws from the surround of the cluster body, unplug the electricals and voila!

1994 Nissan... | Answered on Nov 02, 2015


leave the cap off while it is idling, look in radiator for any air bubbles, if there is you have a leaking head gasket

1994 Nissan... | Answered on Sep 16, 2015


How do I remove the instrument panel in a 1994 Nissan pickup, to change oil lamp bulb?

1994 Nissan... | Answered on Aug 16, 2015


if a gas engine it is symptomatic of fuel air mixture issues....may just need a service/ tune up

1994 Nissan... | Answered on Aug 01, 2015


carberated or fuel injected makes a big difference on what could be wrong .

1994 Nissan... | Answered on Aug 01, 2015

Not finding what you are looking for?
1994 Nissan Pickup Logo

659 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Nissan Experts

Marvin
Marvin

Level 3 Expert

85216 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Pickup Nissan

  • Pickup Nissan

Most Popular Question

1994 nissan pickup truck need driver

  • Cars & Trucks
Loading...