20 Most Recent
2000 Mazda MX-5 Miata - Page 3 Questions & Answers
Why did my 03 mazda
INSTALLING NEW BATTERY.WHEN DISCONNECTING BATTERY CABLES THE ECM WILL LOSE IDLE CONTROL MEMORY.TAKE TO MAZDA DEALERSHIP LET THEM RESET ECM SO CAR WILL IDLE STOP STALLING AT STOPS.
Mazda MX5 Year 2000, started
You may have lost (went bad) a coil pack which feeds ignition fire to two of the four cylinders. Leaving it to run only on 2 will sound terrible, run rough, and have little power.
When i was trying to
sounds like a body fuse (fusable link) may have burned out...
Make sure all of the wires on the negative terminal on the battery are connected well.
There should be one heavy black wire that goes from the negative terminal to the engine block... make sure it is connected firmly.
Where is the fuel pump
Should be located on the fender well under your hood in a black box, The top pops off and the location of your Fuel relay should be marked on the box cover. Good luck to you.
Yellow-brownish pool under car car has antifreeze.
Sounds like an oil Leak. Could be multiple locations the leak is comming from. Suggest using a light to locate where it's leaking from & let me know. or take it to the mechanic if you are not comfortable attempting auto repair
Battery was completely dead- so
That would probably be your alternator. The car doesnt take as much power to keep running as the lights. The lights use alot of power and if the battery is doing the alternators job it drains quickly. The battery is only designed to start the car then the alternator should take over and recharge the battery. When the alternator fails the battery will soon fail. Even though you had to jump the battery it was still new so it had a big charge. That is why you were able to drive so far. On an old battery and a jump I've seen people drive a long ways until they turn on their lights. I say 99.99% sure it's your alternator. Here is how you can test it. Get your car jump started again or charge your battery and start your car. While it is running get out and unhook the positive battery cable from the battery. If your car dies, you have found your problem(the alternator). I hope that I could be of some help. Good luck.
Check engine light on
check engine light always coming when some fault registered in your computer.it will be electrical or mechanical problem.so you have to consult the technician and let him to check with his diagnostic machine.then we can recognize real position where having problem.so ,you can repair it.
Location of fuel pump for mazda mx5 2000
Removal & Installation
Through the trunk servicing panel...
-
Before servicing the vehicle, refer to the Precautions section.
-
Properly relieve the fuel pressure.
-
Remove or disconnect the following:
-
Negative battery cable
-
Rear package trim
-
Service hole cover
-
Fuel pump cover
-
Fuel pump connector
-
Fuel hoses
-
Fuel pump and gauge sender unit as an assembly
-
Fuel pump from the sender bracket
To install:
-
New O-ring set
-
Fuel pump to the sender bracket
NOTE
Pull the fuel pump down so that it is tight against the bracket.
-
Fuel pump and gauge sender unit as an assembly
-
Fuel hoses
-
Fuel pump connector
-
Fuel pump cover
-
Service hole cover
-
Rear package trim
-
Negative battery cable
My 2000 Mazda Miata MX-5
If it's cold water and you've been running the AC, it's condensate. The drain line is clogged and that is overflowing into the cab.
Locate the line, clear, clean, reattach and you should be fine.------
Try this:------
Go down into the passenger footwell carrying a jar or something. There is a black box above the passenger's left foot; this is the capture pan for the condensate. On the tunnel side of this is a " component", from which a black tube goes through a hole in the tunnel. Pull the hose off the "component" and capture the surge of water. Then use an oversize pipe cleaner of small diameter bottle brush and clean out the area of the "component" inside the box. Clean out the tube.
The drain for the evaporator case is probably blocked by debris. Get under the car, and look on the right side of the tunnel near the firewall. There will be a short piece of black hose protruding from this area. A coathanger or a bit of compressed air will work wonders. If the clog is too bad to be loosened this way, you may have to have the evaporator case removed and cleaned.
Thanks. Keep updated for any more query. You can rate this
solution and show your appreciation.
Spider nest behind the dash
If there is a spider nest in the car you can simply use insecticide spray to spray the spider nest that will get rid of them,you can also spray the nest with air freshener that also will get rid of the spiders.
I have a 2000 Mazda
Hello! When you crank the engine in the no-start condition, does the tach move? If it does not move The Camshaft Positioning Sensor...OR...The Crankshaft Positioning Sensor is the problem...You can buy a spray can of Freeze...Spray each component when fault is present...If the trouble clears you have found the guilty part...Guru..........saailer
I’m happy to help further over the phone at
https://www.6ya.com/expert/david_6df67de3b14de867
Firing order and which plug coil connect to
The firing order for Mazda MX-5 Miata is
1-3-4-2
For exact connection for both 1.6 and 1.8 check the connections in the figure below:--
Thanks. Keep updated for any more query. You can rate this
solution and show your appreciation.
Hi
I have a 2000
Check Engine Light is turned one when the engine control module detects a fault in the ECM system - usually in the emissions system. One or more diagnostic codes will be stored in the engine module and these codes are the information you must use use to diagnose the problem. But an not so uncommon cause for an ECM malfunction on a Miata is an old battery: clean the clamps and the battery plugs with wire wool then test the voltage with both the engine on (around 14.5v) and off (above 12v).
Yes, all the symptoms you describe are what you would expect from an engine with the CEL lit.
How do I remove the
fairly straightforward
1.) disconnect the battery
2.) remove the meter hood
3.) remove the following
How do you remove the
If noone has the info I would go to mitchell1diy online and for ten bucks pay for all the procedures. It may have what your looking for.
Please do not rate me unless its good since I really don't have a perfect answer for you.
Not finding what you are looking for?