20 Most Recent 2002 Ford SVT Focus - Page 9 Questions & Answers

the ports will be on the passenger side of vehicle...near fire wall or a nippled (with a black cap) right next to the headlamp bucket....just follow the ac lines and you will follow

Verify you have it on correctly. Make sure you purchased correct belt. Is the tension pulley bad. If it is, it will need to be replaced.

Gonna do my best to give you details on the location. On the engine side of the wheel well (passenger side) looking up from underneath the vehicle you will see the accumulator/dryer. if you reach up along the back part of it (towards the back of the vehicle) about 6 to 8 inches up if you feel around you will feel it. You will still not be able to see it but you can feel it. the high side was easy to find I bet. It's there believe me. the first time I had to do one, it took me about 20 minutes to find and this is what i do for a living so you're not alone. I hope this helps and good luck.

If the oil is on top of the plug, your valve cover gasket is leaking. (easy fix). If the oil is on the bottom of the plug (on the screw threads) you have a problem. It could be a burnt valve, blowed piston ring, or even a head gasket. Please let me know more info on EXACTLY where the oil is coming from. Hope this helps, James Booth

first check the terminals on rear window,may be lose or disconnected and you can measure the ohm of this heater .

Take the radio out, note the serial number and call the Ford delership and they will give ya the code.

Hello carrollrll,

Fix the third brake light and that should resolve the cruise control issue.

The cruise control circuit that deactivates the cruise is through the third brake light.

Regards,
netvan

Hi and welcome to FixYa!

First you may check on the ground wire. Black in color, it may be loosen and needs to be secured for the brake light to operate normally.

Hope this helps and thank you for using FixYa! Have a good one!

If a bulb blows white the gas mix in the globe is incorrect and you probably got hold of a bad batch of globes from your supplier. Try buying your bulbs from another source and see if that works out better.

Sounds like it clutch master cylinder or brake master cylinder/ booster is leaking. Check your fluid levels.

If the key won't turn in the lock cylinder a locksmith can replace the parts by taking the door apart. Sometimes a worn key won't turn the cylinder on one side and a new key can be made by the key code. A locksmith has the codes and tools.

check engine on scanner for fault code

I would recommend that you change the transmission fluid. Most people do not think about changing it in a manual transmission, but it should be done on a regularly scheduled maintenance.

Complete guide found here
http://www.focusfanatics.com/forum/showthread.php?t=184383

Hope it helps

Positive Feedback ALWAYS Appreciated :)

www.autozone.com has all sorts of online guides with this information. It does require registration, but it is simple to do.

Your computer is reading engine knock. Do not drive under hard conditions. You need to have it check out by a mechanic.

Clint, you might want to check your break switch to see if your button is stuck. It is right above your brake pedal. The pedal led actually hits the button of the switch. See if you can loosen it.

Have you checked the bulb?