20 Most Recent 1992 Nissan 240SX Fastback Questions & Answers

Starter motor or solenoid is going bad or cables are corroded. Clean all cables if car does not crank have someone try to crank it while you "smack" the started motor housing with a hammer or a long solid rod (hitting the rod with the hammer as it rests on starter motor case). Hit it sharply a few times. If it starts, then the starter motor is bad.

You will need to flush the steering system and then replace the steering rack and pinion assembly to cure this issue.

Clicking indicate poor connection between battery posts and cable clamps...clean them

You would need a repair book with wiring diagrams to troubleshoot the ignition system. You would need to know if the coil and module are getting power to begin.

Sounds like you need to adjust your clutch. Go to the library and get the automotive repair manual for your make and model of car. Look up the section for clutch adjustment. You'll have to decide whether or not you think you can do it.. You probably can if you have any hand tools...

If the battery is holding a charge, I would look at the alternator.

VIN number = Vehicle Identification Number

Just is one identification number and know that the glasses be retaled with this vehicle.

Hope helps.

It could be many things, i doubt the re-bore is anything to do with it. Firstly check to see if you have spark/fuel supply to the engine. The probable cause is down to a loose injector harness earth wire. Check the wires you took off paying particular attention to the engine earth wire. Hope this helps...

When replacing head gasket you had to disconnect and move spark plug wires and coil wire.Sounds to me if it ran for a little while then died out look for a burned wire by exhaust manifold.Something must of shorted out.Thats why it ran a little while and died.

If your wires are not properly grounded, your car will not start.