1994 Chevrolet Cavalier - Answered Questions & Fixed issues
My 1994 3.1 chevy cavalier has a leak . its the L hose, the inlet tube broke off right at motor, and now we dont know is how to get broken peice out
It's a plastic piece, right, like an elbow fitting?
Only two ways those are held in the engine: they have threads and screw in, or it is a smooth fitting just pushed in with a rubber O-ring on it to keep it from leaking. If it is threaded, stick something just bigger than the diameter of the hose into the broken off piece and try unscrewing it out. Not as hard as it sounds, I have seen those just turn right out easy (most of the time!).
If that broken off piece is smooth with an O-ring around it, you might need something like a stiff wire with a little hook or "L" on the end, stick it in past the fitting and get that hook on the end and yank it out.
Good luck.
How do i change the fuel filter on a 1994 chevy cavalier?
Make sure no pressure on the fuel system before taking anything loose. Usually after the vehicle sits overnight w/o the key being cycled, there shouldn't be much pressure, but, you still need to be aware of possibility. Use a catch pan for any gas that might run out of fuel lines. Sometimes loosening the gas cap can help, sometimes it doesn't. If you think too much gas is running out of fuel lines, plug line till you go back with new filter. If new filter has arrow, the arrow points toward engine. Do the work in open air, not in a clos3ed garage where there might be pilot lite of some kind. If you use a drop lite be careful where you place it.
If the filter has threaded fitting on one end, use a couple of wrenches to take loose. If the other end of filter has a quick disconnect, some of these, I have taken loose with a pair of needle nose pliers.
As far as safely raising and supporting the vehicle, where applicable. Safety is your responsibility. Never use only a jack to support the vehicle.
How do I get the window crank handle off to remove the inside door panel?
W thurber, there is a cheap tool for this, in a jam you can cut and bend a coat hanger, straight section for your handle 8", bend 1/4",
slide this behind handle and feel for clip and pull up sharply.
Clip is shaped like horse shoe with small tangs for hanger bend to catch. It may come off and you wont notice till you pull on handle.
PRESS THE HELPFUL BUTTON AND FOLLOW ME ON FIXYA FOR MORE TIPS
Abs ana brake light on
That light tells you something is wrong with the abs/brakes! Unless of course the sensor is defective.
Better start checking. Your life may be at stake.
Abs light flashing
You will need to check codes to see what computer sees. Auto Zone checks codes for free.
Not finding what you are looking for?