1990 Nissan Hardbody King Cab - Answered Questions & Fixed issues

what nissan model do you need the head torques for

Most likely the wheel lock vacuum motor is defective o rhas low vacuum from the engine.

it appears that you have to check beginning at the Battery on to the Fuse Box, down to the Starter, and on to the Ignition

You will need to remove the cyl head and check for corrosion and/or cyl head gasket. Best is to take the cyl head to a reputable machine shop for testing and service.

On the cap

If power is not found at the a/c clutch, the relay is faulty. If power is found, suspect a bad ground, or a defective compressor. the relay in your car controls the ac compressor, but check main a/c fuse first, to see if that is ok! is power going from switch to relay. if so the relay is bad. thats why it will not go to compressor. Good-day! But you can go to this site for more info--.ehow.com/how_5730046_tell-bad-ac-relay

This indicates a broken timing belt and will require the front of the motor to be pulled of to replace it . I suspect that you will have bent valves as well so the head will have to come off for then to be replaced . To do the job properly to obtain maximum life from the new belt ,Cam shaft seals ,crankshaft seal, hydraulic adjuster( if applicable), all idler pulley bearings must be replaced . The seals because oil destroys rubber belts well before due time and the pulley bearings will be worn out and will not see another full time period.

YOU HAVE A FUEL FILTER AND A FUEL STRAINER AT FUEL PUMP . HERE'S THE FUEL FILTER AND HOW TO REPLACE.

Could be this.Here's what it looks like and what it will do if bad.

sometimes its because of an aftermarket alarm system or a natural gas system. they both latch on to that circuit to deactivate the pump.

Possible that the brake light pressure switch is not activating or the activating switch on the pedal.
trace the voltage from the switch to confirm. also check the voltage at the lamp assembly - faulty rear lamp assembly or ground to the unit, fused lamp.

You have a defective turn signal switch. Pull off the steering column covers and replace the switch.

When the a/c system is filed with gas this contains an oil component.

I HAVE THE CODE ,BUT I CAN`T ENTER IT.PLS HELP

Give some more details of the problem.

You have to leave your radio on for 60 minutes and then it resets to "code in"It works I tried it today

error codes in 2004 4x4 nissan hardbody radio b/cab how do i reset it

Brake cleaner does the best job. Good luck to ya.

Its a complete guide with proper instruction and diagrams.please click on the link below.:---- http://technoanswers.blogspot.com/2011/03/how-to-replace-starter-on-1994-nissan.html ------------- This should help.thanks.Helpmech.

Below is a link to basic instructions to replacing a wiper motor. I hope you find it of use:

http://www.automd.com/77/how-to-replace-a-windshield-wiper-motor/