20 Most Recent
1998 Chevrolet Camaro Questions & Answers
My v6 camaro vibrates pretty
Is it a standard trans?
If so,does it does the vibration (with the trans in gear and your foot holding the clutch pedal down) disappear or is reduced?
If it is better then the clutch disk may be damaged.
Seat belt light doesn't turn off even when the car is turned off.
You have either a short to ground on the black/white wire going to the seat belt switch or you have a bad body control module. Disconnect connector C3 at the body control module and check for good ground with the seat belt UNBUCKLED. If you see that, it's the BCM
Code p0300 1998 chevy Camaro. Car does not turn over.
None of these codes by themselves will prevent the car from starting. I would look over the O2 sensor wiring. Maybe the harness is resting on a hot pipe. You can test the components--the sensor and both solenoid valves. Maybe there is a problem at the canister. Unfortunately, the canister and vent valve are atop of the tank, but you can still hear if the vent valve is closing when you apply ground to the white lead. The p0300 is the most likely code to affect starting. Are you getting sparks? If not, suspect the ignition module under the coils. I drive a 2000 Camaro, so I'm pretty familiar with this model.
98 Camaro Headlights wont work
Dash lights were falsing ? I assume you mean pulsing .
driving lights come on ? daytime running lights or park lamps ,does the vehicle have daytime running lamps . Daytime running lamps module .
Daytime Running Lamps (DRL) Module (Headlamp Auto Control Module)
Mounted behind the radio and the HVAC control, left of the instrument panel compartment.
Not finding what you are looking for?