20 Most Recent
1992 Chevrolet S-10 Questions & Answers
1992 chevy s10 ecmb fuse blowing. What is wrong?
The fuel pump circuit was a common cause for this . Any place between the pump and fuse can have a bare spot in the insulation intermittently bumping into metal . I believe the injectors may run on the same circuit so check their wiring also .
AC/Heater fan switch replacement
Do you mean the small handle tips on the levers are preventing you from removing the plate? Normally, those tips should just pull off, then the plate can slide off over the levers.
Where is the fuse box
should be in the glove box, or under the driver side dash. May need to remove under dash cover.
I have a 92 chevy
https://s1.postimg.org/89tia75ozz/turn_signal.jpg
Click on the link.
This is for turn signals. Get at the turn signal switch. See the purple wire, L terminal on top of turn signal switch in diagram, that should go hot with key on, use jumper wire from that terminal to one of the wires on bottom of turn signal switch in diagram, those are, front/rear, left/right turn signals. If the turns signals work properly with the jumper, but, other wise don't, the problem should be the turn signal switch. If it still doesn't work properly, you would have to check wiring circuits.
Sometimes a faulty ground can cause weird problems. Sometimes the bulb doesn't make good contact in the bulb socket? Try putting a little pressure on the bulb in the bulb socket, see if it starts working?
Not finding what you are looking for?