20 Most Recent
2003 Oldsmobile Alero - Page 4 Questions & Answers
How to go about replacing the fuel pump in 2003 Alero GL
here is a link to a video that will show You exactly how to fix the
Fuel Pump on Your Alero, the Fuel Pump is inside the Gas tank so
adhere to all the directions on the video to do it safely & Good Luck
https://youtu.be/giURw81hWzk
I have a 2000 Alero Oldsmobile, engine light is
There may be and EVAP solenoid that is leaking. THe OLDS Aurora has this and it is a common failure with this code. Also, the evap lines run to the fuel pump on the top of the gas tank. Some cars have an access panel in the trunk under the carpeting, near the back seat on the right hand side.
Torque specification on a 2003 alero cylinder
3.4L Engine
To Remove:
- Remove the lower intake manifold.
- Remove the exhaust crossover pipe.
- If removing the right cylinder head, remove the catalytic converter from exhaust manifold.
- If removing the left cylinder head, remove the engine oil dipstick and tube.
- Remove the rocker arms and pushrods.
- Remove and discard the cylinder head bolts.
- Remove the cylinder head.
- Clean the mating surfaces on the following items:
- Cylinder head
- Cylinder block
- Intake manifold
- Clean the cylinder block bolt threads.
NOTE: During disassembly, keep the valve train components together for proper location during assembly.
To Install:
NOTE: Coat the cylinder head bolt threads using thread sealer.
- If removed, install the following components:
- Exhaust manifold
- Accessory studs
- Spark plugs
- Place the cylinder head gasket in position over the dowel pins. Ensure that the THIS SIDE UP note is showing.
- Install the cylinder head.
Cylinder head torque sequence ’99-‘00
Cylinder head torque sequence ’01-05
- Install the new cylinder head bolts.
- Tighten the cylinder head bolts a first pass to 44 ft lb (60 Nm).
- Tighten the cylinder head bolts in sequence an additional 95 degrees.
- Install the intake gasket.
- Install the pushrods and rocker arms.
- Raise and support the vehicle.
- Install the catalytic converter and dipstick tube and indicator if removed.
- Lower the vehicle.
- Install the exhaust crossover pipe.
- Install the intake manifolds.
- Connect negative battery cable.
- Fill the cooling system.
How to replace the altenator in a 2003 Olds alero
Remove the coolant reservoir,2 nuts. You don't have to drain it or remove the hose. Set it out of the way. Take the belt off. They make a tool for this. You can usually rent one from a parts store. 1 bolt at the front of the alternator and 2 on the side by the fire wall to remove All 3 are 15 MM bolts.. Pull it loose and out some. remove the plug and power wire. I don't remove the battery cable, but you might want to. Negative side.
The battery of my car does not charge and I put
The main wire from the alternator to the battery is not making connection,just run another one to the positive side of the battery,to the large wire on the alternator,leave the other one on the alternator,just add this one,use as big of wire,or larger,a small cable will do nicely.
Not finding what you are looking for?