20 Most Recent
1997 Oldsmobile Eighty Eight Questions & Answers
Fog light red wire broke off
you can also use shrinkable wire butt connectors but I would go to either autozone or advance or somewhere even wal-mart and get a 2 wire polarized connector for a few bucks and cut all the wires and put the new connector on..use black tape to cover the bare wires for now..after all is just a light..
Where is the fuse panel on a 97 olds 88 ls
It is located to the left under the steering wheel quite a ways. Took me awhile to locate it, but when I found it, it was very easy to read compared to others I have seen.
How to replace the starter
kind of a pain, last on i did i had to remove the front transmission mount and jack up the engine to get at it, there is also a plastic cover that hides part of it.
Replace starter
Depends on what vkind of vehical ,and if you know what you are doing
Starter relay bad
Could be the starter solenoid mounted on the starter, the neutral safety switch, or the key switch. You would need to test the solenoid for power from the key when it fails to crank.
1997oldsmobile 88 wont start
Hi there:You wll have to pinpoint what the engine is missing...- Spark- Fuel- CompressionAll
three of these are tested when the engine is being cranked over. There
are two way of checking for fuel. Fuel pressure and fuel trigger. Both
are very important and must be present for the engine to start. Fuel
pressure is self explanatory. You just hook up the gage and see what the
reading is. Fuel trigger is check with a noid light. The injector gets
unplugged and the noid light gets plugged in to the injector clip. With
the engine cranking over, this light must blink. This is the signal to
the injectors from the computer. You can have all the fuel pressure in
the world, but it wont matter if the injector is not pulsing gas into
the cylinder like it should.Compression tester, spark tester,
fuel pressure gage and noid light are all accessible at your local auto
store. All three tests play a very important part in diagnosing a no
start condition. Be extremely careful when doing these tests.Hope this helps; also keep in mind that your feedback
is important and
I`ll appreciate your time and consideration if you leave some
testimonial comment about this answer.Thank you for using FixYa, have a nice day.
Not finding what you are looking for?