20 Most Recent 1994 Oldsmobile Cutlass Supreme - Page 7 Questions & Answers

That year does not have a MAF sensor. It uses a MAP sensor instead. I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

dont think that used a cable i think it uses a electric speed sensor near the right side of the trans

check the wiring to the lights as well as the fuses

you need to find a auto apolstery shop

HUGE JOB.BUT IF YOU HAD ALL THE TOOLS YOU CAN.YOU NEED TO TAKE OUT :CARB,CARB INTAKE,ALL CABLES AND LAST THE HEAD COVERS THEN THE HEADS.

check your ignition fuses under the hood

I would first make sure that the locks are the problem before jumping to replace them. Check for power and the lock actuator before you do any thing make sure there is power there before you replace a lock solenoid.If there is not power at connector for lock solenoid when pushing the button then you must trouble shoot the system to find out why or you will have new locks that still dont work. youy can buy a chilton manual but they are very vague on some items.

You are correct in that the AC cooling fan is controlled by the ECM, the problem is the sensor on the "Hot" side of the motor, which should be either right ON the thermostat or very near it. Change this, it should take care of issue.

take the motor mount bolt loose on one side the slide 2X4 up under exhaust manifold and jack slowly lift making sure you clear fan shroud and all hoses electrical wiring is disconnected, should be able to slide it back and down not to damage sump that's inside of pan .

assuming it's a 3.1 it's about 1/2 way up the block in the rear of the engineabout midway between clys.2 and 4. Have to get it from underneath probably.it's about 2 inches long but all you can see is the very end with a connector clipped to it.Held in with a single 10 mm bolt and it slides out of the block.

start with the basics, does the fuel pump work, do you have spark, do you have injector signal, are the fuses good, lots of variables here

most likely in the trunk perhaps behing the mat by filler tube

I provide wiring diagrams on a private website for a fee, let me know if you're interested

check fuel filter or fuel pump

take your glove box out, and replace your fuse that says tailights and/or dash lights. Its a 15 amp fuse, replace it, and you will have taillights