20 Most Recent
2003 Dodge Dakota Club Cab Questions & Answers
We have a 2001 dodge dakota quad cab, window on
2001 dakota
I think you should try this website link that I have attached. It helps you repair your vehicle easily without more help. Ask the girl in chat at the bottom of the page on reliable-store com
or try manualslife com but they don't have any live help tho
but both are pretty good
I lost running lights on a trailer that I pull
if you have running lights on the dodge , the fuses are ok
check the harness connections including the ground wire in the trailer connections as the directional lights may be using the running lights as a ground
How do I no my solend is bad
A code P0442 most likely means one or more of the following has happened: A loose or improperly affixed gas cap A non-conforming gas cap (i.e. not factory/original brand) A small leak/hole in a fuel vapor hose/tube Other small leak in EVAP system Faulty vent o-ring seal Defective vent valve Defective purge valve Defective leak detection pump
Read more at:
http://www.obd-codes.com/p0442
Copyright OBD-Codes.com
My truck is throwing a code that says pdome
I believe what you are seeing is PDONE I would assume that the code is being retrieved via cycling the ignition and that code means the system is "done" displaying codes.
You may have missed the codes that were displayed or it may have met a condition that caused the light to come on but no code to actually register. I would suggest going to an auto parts store and have them actually read the codes with a device just in case it is not displaying correctly.
2003 dodge dakota will not turn over
Get codes read at parts store or get friend with scanner to check them. Note: you should not smell fuel in throttle body as fuel never goes there. Could be bad crank sensor/cam sensor, fuse for ignition, module, others.
Replacing headliner cheap
You need to take all of the hardware that holds the liner up. Take the liner out slowly ,not to damage it. You will have to remove the material and or sponge by hand.(do not peel layers)A good fabric shop will have replacement material. Bring a piece of the old fabric with you to match color of fabric.3M does make a headliner glue sold at a parts house to replace material. Measure liner from front to back ,not side to side. What I am saying is like from the rearview mirror to the back glass. Add at least a foot or two more to measurement. You will have to cut out holes for the hardware after you glue it down to the shell. You will also have to roll the material over the sides and glue the backsides. What I am saying about this is there is no molding where the shell meets the rearview mirror so roll it and glue it to the backside of shell , do the same for the back glass area of the shell. Use care when spraying glue not to get glue on the fabric. When you roll the fabric over and glue it you can hold the fabric down with a folded piece of cardboard held with clothes pins .Replace shell about 8 hrs later. Do not do this on a rainy day ,make sure it is sunny or hot day . Also when you spray the glue spray the shell and the sponge side with glue but do not over saturate the sponge or board that it would seep through the material. Good Luck!
Not finding what you are looking for?