2000 Dodge Caravan - Page 7 - Answered Questions & Fixed issues
Steering wont lock key wont turn
steering locks mechanically 180 turn,tumblers sticking in cyl like its the wrong key.Try tapping the key inward then turn if this works tumblers are worn then cyl needs to be replaced.
3/17/2015 1:46:59 AM •
2000 Dodge...
•
Answered
on Mar 17, 2015
•
92 views
Key wont turn in igniton
Wiggle wheel and try or get new key from dealer about eight bucks trough the Vin number
3/15/2015 1:57:59 AM •
2000 Dodge...
•
Answered
on Mar 15, 2015
•
62 views
Fuse is ok no power to blower motor switch
Check the relay fuse under the hood. It is located in the fuse box on the fender. If the relay is bad you can replace it. Check it with a voltage meter. If it's not the relayit's probably the switch itself.
Hope this helps
h3mster
3/14/2015 3:37:25 PM •
2000 Dodge...
•
Answered
on Mar 14, 2015
•
71 views
How to reset timing on van?
turn the crank over until you have tdc compression stroke on the harmonic balancer lined up with the timing mark
position the rotor button facing no 1 plug lead and put the distributor in maintaining the point
3/14/2015 9:51:21 PM •
2000 Dodge...
•
Answered
on Mar 14, 2015
•
128 views
Why do my door locks stop working when I try to install a stereo in my 2000 dodge caravan?
Hi Tony, I'm AL the owner of Big As Auto Repair
I look forward to helping you with your problem!
Tony, most likely you have hook your stereo into wiring that is interrupting the signal that comes from the computer to unlock the or lock the doors. The best way to see if this is your problem is to unhook the stereo and see if the problem goes away. If it does you'll need to hook the stereo to some other wiring. If you problem is still there you'll need further assistance. Click here for Help!
Auto Repair
3/8/2015 4:38:50 PM •
2000 Dodge...
•
Answered
on Mar 08, 2015
•
102 views
How to change headlight assy on 2000 dodge caravan
Remove the screw from the black tab on top of the headlamp assembly. Around the headlamp plug, there are 3 nuts, remove them carefully, as they are easily dropped and lost, remove the ring that secures the bulb to the assembly, it only turns a portion of a turn. Slide the entire headlight assembly partially out the front, then disconnect the rubber plug that contains the marker/turn signal bulbs. Re assemble in reverse order, making sure the headlight bulb is properly aligned or the ring will not tighten. Also,take care not to touch the headlight bulb glass, as the oil from your fingers may cause the bulb to break when it heats up. Hope this helps.
2/26/2015 10:32:56 PM •
2000 Dodge...
•
Answered
on Feb 26, 2015
•
289 views
My dashboard lights and panel went out, how do i fix this?
This could be a couple of things. First, have you towed a trailer recently or do you have a trailer hitch with light connections? Check to see if the the "running or parking" lights work on the outside of your van. If they don't start looking for a shorted wire since the dash lights are usually on the same fuse circuit as the parking lights are on. If the outside lights work and the fuse isn't blown then your headlight switch is probably to blame and will need to be replaced.
2/24/2015 8:54:00 PM •
2000 Dodge...
•
Answered
on Feb 24, 2015
•
76 views
Locate fuse for dashboard lights
Check for a fuse box underneath the dashboard in the drivers side. Some times there is a plastic lever that needs to be pulled down in order for the fuse panel to swing down. Check your car manaul to see where the dasboard light fuse is located, some times the fuse can be located in the engine compartment where you will find a rather big black plastic box with relays and other fuses. Another fuse box location is found on the passenger side underneath the dashboard or kick panel, better to check the owners manual so you don't have to look into all 3 locations.When you do find the right fuse block, look for a fuse that is labled Insturment Lights or Cluster Panel, that usually indicates the dashboard light fuse. The fuse used in most dashboard lights is around the 15 to 20 Amp range.
4/27/2016 7:03:41 PM •
2000 Dodge...
•
Answered
on Apr 27, 2016
•
697 views
Dash indicators intermittent
Hi there
Either loose connection under dash or bad connection on earth on battery or chassis or loose term on alt/ engine /chassis etc
2/16/2015 2:20:08 AM •
2000 Dodge...
•
Answered
on Feb 16, 2015
•
37 views
Not finding what you are looking for?