20 Most Recent
- Page 7 Questions & Answers
How does the rod connect to the latch
there's a plastic clip that holds the rod into the handle unless ur handle is broke ,u can get that clip in the help sect. at ur local auto parts store or a salvge yard the clip should b in the bottom of the door
on Jul 19, 2015
How do you pullout a transmission on a 2000 dodge
transmisssion comes out from under vehicle.jack up vehicle or place on lift if available. first remove front tires, in center of brake rotors remove large nut in center. disconnect lower control arms on left and right. pull both left and right drive axles. disconnect all cables connected to transmission, disconnect two transmission cooling lines, remove lower frame connected to vehicle body and transmission and engine. remove inspection cover on transmission, remove eight bolts around outer edge of transmission, remove four bolts that connect torque converter to flywheel.slide transmission out horizontally to remove.
on Jul 15, 2015
It shut off while I was driving and now it won't start
The things to check are: is the engine still getting fuel and spark. Do you hear the fuel pump buzz on for 2 seconds with key in on? It has to turn on for 2 seconds to prime the lines and fuel rail on the engine-where the injectors sit. A fuel pressure gauge could be hooked up to test the fuel pressure, with key on. No pressure means the pump is not working right, not coming on. Either the pump has gone out, or the fuel pump circuit has a problem.
If gas is getting to the engine, then check for spark on a spark plug wire. No spark when cranking the engine over means there is a problem in the ignition system- spark plugs, plug wires, ignition coils (the coil pack), ignition control module, the pcm, the crankshaft position sensor-all of these components need to be checked. Buy a cheap spark tester and start there.
on Apr 28, 2015
Not finding what you are looking for?