20 Most Recent
1999 Dodge Caravan - Page 9 Questions & Answers
Map sensor
map sensor located on the intake manifold near the throttle body. inlet to the intake manifold.
Tcm module
let it dry out dodges were famous for getting the distributer wet and it running like crap. you have a spark module i beleive if you got some of your electronics on the motor wet they need to dry
I have a 2009 dodge Ram 3500 cummins and there is
Check your brake master cylinder-your reservoir should be low if the master cylinder failed, and fluid could leak into the brake booster. Might be how the fluid winds up down below the brakes.Also, could be from the clutch, if you have a manual with hydraulic clutch. Whichever it is will require replacing. Are any abs lines up under dash?
Oil light comes on when the engine is full of oil
That's because it has nothing to do with oil level. It is a low PRESSURE warning and the engine should be shut off immediately when it comes on until it is determined as to why it came on. Your first step is to take a mechanical pressure reading to determine if the light itself is faulty.
1998 dodge carravan where is the ecm
The ECM (Engine Control mModule) is under the hood on the drivers side on the right of the battery on the fender,...3 screws hold it to the fender. You will need to partially remove the Power Control Module (PCM has all the fuses and relays) right next to the battery
Brake lights quit working...checked fuse,bulbs and
I would start with the brake light switch.You should have power in and out of the switch when it is engaged.You can find wiring diagrams online by doing a search or by checking the auto parts stores. Some stores will let you register for free and get access to repair info.
Heater won't switch from hot to cold ?
try going to autozone have them look up heat sensor relay this controls the temp hard to get to either on the firewall or just under the windshield at the bottom of thewindshield you have to remove granding were the wipers come out off
Check engine light is on with code p1698 what is
The code P1698 is: No CCD messages from TCM. That means the communication between the Transmission Control Module and the Power Control Module is lost. Sometimes this happens when a PCM, or TCM is replaced without being flashed, a bad connection at the PCM, TCM, or a bad TCM. Hope this helps.
Not finding what you are looking for?