20 Most Recent 2005 Chevrolet Aveo - Page 8 Questions & Answers

On your starter is a small post that activates the starter. the wire comes from the IGN Switch.. when you turn the key power comes down this wire and powers them solonide to engage the starter,

Get the book to be sure there are a couple of ways to time that car the book will show you the right way

please go to this site on your pc browser. for complete info, (wiki.answers.com/q /how_you_install_a_thermostat_on_a_chevy_aveo) Good-Day!

have the OBD codes read at a garage this will tell you what the problem is could be simple like a sensor or more serious like head gasket good luck

You cant it is a led in thecircuit bord it is weld not a good edea

I will tell you how I do it! take a bar or big screwdriver to hold it from turning, if that wont work. sometimes you can position a pipe wrench cross wise, and hold it so the pulley does not turn. good-day!

the valve cover is tighten in inch pounds 70- 100 inch lbs 6- 8 ft lbs.

First you need all new bolts, they are a one time use so called torque to yield bolt. There is not really a specific setting, you turn them in degrees to obtain proper clamping. Here is the info.

to hold down what?

2 possible problems,,a fuse burnt out in the fuse box,,or the fan relay at the fan went out,,.

before you go changing the starter check basics battery terminals clean real good take battery to autopart store have tested go from there

put car in nutral and try if it starts neutral safty switch cld b issue if key has a code chip in it if its wore down could cause this

I got same problem when I first got the car (bought used), took me a day to find out one of the fuse blown caused the problem now I always have 10A fuse spare in my glove comparment, check all your fuses (I believe it's an Audio/Clock 10A fuse) will solve your, good luck ...

i replaced the caliper and then the caliper brake hose, and i drive it 3 to 6 miles and drivers side hangs up again, let it set for about 20 minutes and then i can drive it another 6 miles before it hangs up again, new brakes, new caliper, new hose, so what is making my front drivers side brake hang up?