2005 Chevrolet Malibu - Answered Questions & Fixed issues

It has a fusible link an it is connected at the starter solenoid B+ terminal .

2005 Chevrolet... | Answered on Oct 20, 2019 | 48 views

anti theft system light blinks car won't start, crankes but won't start help?

2005 Chevrolet... | Answered on Jul 11, 2019 | 675 views

there is a lock which is locates bottom side of head rest.

2005 Chevrolet... | Answered on May 13, 2019 | 41 views

You got another computer from where ? Was it programmed ? Anti-theft system key's programmed to new computer also ? Oil pressure switch is in the black connector - have seen bad oil pressure switch wick oil through the wire strands into the computer ,also bad coolant temp. sensor do the same thing .

2005 Chevrolet... | Answered on Jan 30, 2019 | 54 views

the key lock is stuck, you can bypass it by break the key lock,

2005 Chevrolet... | Answered on Jan 03, 2019 | 1,021 views

have you done a compression test on all cylinders ? if no then do so ,find the problem cylinder possible valve hanging open thats possible ,that would mean looking under valve cover

2005 Chevrolet... | Answered on Sep 05, 2018 | 134 views

owners manual or service manual from auto parts store should tell you how to dis arm alarm system

2005 Chevrolet... | Answered on Aug 12, 2018 | 1,128 views

Did you have it checked for code's ? The PCM / ECM supply's Battery voltage to control ( energize ) the fuel pump relay . Using a voltmeter you can check for B+ voltage at pin 85 or 86 ,which ever one comes from the engine computer ,the other goes to ground . This is provided the anti-theft system light isn't lit . Watch this video on testing at the fuel pump relay GM vehicle's
GM Fuel Pump Relay Testing

2005 Chevrolet... | Answered on Jul 14, 2018 | 86 views

Have you replace battery, had charging system checked? there is a fan motor resistor assembly that has the speeds. the hi runs directly from car electrical, replace resistor assembly . an auto parts store has them, They may also check your charging system.

2005 Chevrolet... | Answered on Mar 24, 2018 | 98 views

Bad shakes. I know of nothing other than suspension / wheel issues that will cause this. Since this is an auction car, try looking up the service history for your VIN number online. That would tell you of significant damage in the car's past.
Take the car to a tire store and have the wheels balanced. If the tech's can do this without problem, then the tires and wheels are probably fine, on to suspension. Take the car to a body shop and have them check the frame and suspension components. Checking should be cheap, it is fixing that costs.

2005 Chevrolet... | Answered on Mar 17, 2018 | 43 views

Here is a video of the removal of the front seats of a Chevy Malibu that is in the same series as your 2005 (this video is applicable for 2004 - 2012 model Chevy Malibu)

2005 Chevrolet... | Answered on Jan 31, 2018 | 508 views

This is a known problem and is caused by a faulty hazard switch. Replace that and your problem will go away.
Turn Signals Problems on Malibu Impala Alero Cutlass Grand Am Monte Carlo...

2005 Chevrolet... | Answered on Jan 05, 2018 | 365 views

If a 12 year old car is overheating, the owner might want to have the cooling system checked. the correct amount of and type of coolant in the radiator. no leaks anywhere in the system. radiator cap and water pump working correctly belts are in good condition and with the correct tension. Engine block thermostat working properly and in good condition. No obstructions in the engine block or radiator. All the hoses are good and not leaking.

2005 Chevrolet... | Answered on Dec 24, 2017 | 319 views

You can get complete manual here also with coding cracks and everything. I have attached link for a website that I personally use.. Best Manuals

2005 Chevrolet... | Answered on Nov 27, 2017 | 59 views

In Underhood fuse box or called Convenience center you have 2 seperate fuses one is a 80 Amp fuse labeled EPS fuse # 41 other is located in bcm 2 amp fuse. I recommend having a experienced technician diagnose bcm fuse as it is internal. just fyi . I posted above diagram with info above. good luck

I’m happy to assist further over the phone at https://www.6ya.com/expert/james_9ddabbbc483e2add

2005 Chevrolet... | Answered on Nov 22, 2017 | 2,876 views

Have you ever had the rotors turned (reconditioned)? If you have you need to replace them. Once they have been turned there is not enough metal in them to dissipate the heat generated from the brakes. If that is not the case you may want to upgrade your disc brakes and your drum brakes to a higher quality pad. I use RockAuto.com pretty often as they show you quite a range of replacement/performance parts from the low end of the price spectrum all the way up to high performance parts. If the brakes are keeping pressure on the drum or are keeping in contact with the drum, you need to have the brake shoes properly adjusted. This is part of normal maintenance. If the disc brakes are keeping in constant contact on one side or the other, be sure the disc brake slides are properly lubricated and not sticking.
RockAuto Parts Catalog

2005 Chevrolet... | Answered on Nov 14, 2017 | 170 views

Not finding what you are looking for?
2005 Chevrolet Malibu Logo

1,918 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts


Level 3 Expert

85223 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides