20 Most Recent
2006 Mitsubishi Colt Questions & Answers
My Mitsubishi colt CZ1 (07
Central locking works by way of little electric motors that engages and disengages the door lock. The drivers door has an additional set of contacts in the actuator which signal the controller when it changes position. The controller activates the servo motors when a signal is received from the receiver or from the drivers door servo motor. So in your case I suspect the motor part of the drivers door actuator is done for.
To replace you will have to remove the inner driver's door panel to get at the actuator. The actuator itself cannot be repaired and needs to be replaced as a unit.
EPS warning light on on my Mitsubishi Colt (2006).
My EPS on my mitsubishi colt 2006 stopped working about 8 months now, I changed the electronic box,but it started to work for ten minutes and then stopped.I carried it by some electricians and they put the computer on it, but it is not getting through.Could someone lend some assistance!!!!!!!!!!!!!!!!!!!!!!!!1
The eps light comes on in my dashboard and the
First you have to check power steering fluid level, and if it's ok then you have to check power steering pump. If you have a EPS light on your dash, then you have to plug a ODBII diagnostic tool to read code and then interpret what the problem is.
Have a mitsubishi colt glx,
Sounds like you have a fuel issue i recommend replacing the fuel filter it is the first and cheapest option. contact me for assistance with removal and installation for your vehicle.
Do you have an oil flow diagram for Mitsubishi colt 2,8 tdi 2006 model.
There are no diagrams of that that I know of //// oil is pumped into the engine and travels through the engine block to lubricate the cam and timing chain/s OHV OVERHEAD VALVES nto the valve lifters then up through the push rods into the cylinder heads to lubricate and cool the valve springs and the cam/s if Daul overhead cam THERE'S 2 AND 2 CHAINS THAT'S HOW THEY WORK WHAT IS THE PROBLEM IF ANY THAT YOUR HAVING?
Bought a Colt CZ3 in Oct. '05. the steering always
indicates a wheel alignment problem
have the rear suspension checked and aligned first then have the front redone
the car could be going sideways down the road because the rear wheel are not in line with the front tires
not self centering and stiff indicates not enough castor
Colt ecu change
The ECU would have to match the part number EXACTLY. You're much better off getting your current ECU rebuilt and programmed by the rebuilder.
55 plate colt
The sensor is behind the bumper reinforcement panel.
Green four wheel drive light flashes when driving normal operation
If it engages in 4WD and works noramly in 2 and 4 wheel .
Then I would look to the switches . A lose wire bad connection or if a cable is involved a slight adjustment
Dosn't sound like you have a big problem .You will have to do a little research on how the system works being some are vacuum with cable some electronic even the same vehicle same year im not sure what Mitsubishi used in the colt in that year .
But mitsubishi are build very well good engieneering
Not finding what you are looking for?