20 Most Recent
2002 Mazda Tribute - Page 5 Questions & Answers
How do you remove a brake drum from a 2002 Mazda tribute lx
If it doesn't have a bolt or screw that hold it to the axle then the drum may have a grove cut in it from the rivits from the worn pads . In the rear side of the drum plate you should find a rubber plug , remove it and them you will have to use what's called a brake spoon to adjust the brakes down until the drum will come off . Be careful turning it one way loosens the other way tightens it
Where is DPFE sensor 2002 mazda tribute V-6
Between the engine and firewall. there is a metal tube that connects to the exhaust manifold and the EGR valve. EGR is close to the throttle body. On this tube you will see two other tubes coming off it, with rubber hoses attached. On the other end of the rubber hoses is the DPFE sensor. It has an electrical plug, wit two wires.
Can an EGR valve be tested to check for failure ?
without doing the above reply I suggest hook a computer to it, or troubleshoot, is there plenty of exhaust coming out of your tailpipe, 2. is your cat hot? are you getting terrible mileage, is the engine performance slow and if you have all of these replace the valve.
EGR valve Mazda 2002 V-6 Tribute replacement
- Remove the EGR valve.
- Disconnect the vacuum line.
- Disconnect the EGR tube.
- Remove the EGR valve and discard the gasket.
NOTE: The EGR valve sealing surfaces are soft metals.
- To install, reverse the removal procedure.
- Carefully clean all sealing surfaces and install a new EGR valve gasket.
Gear shift stuck
EITHER IT IS CONNECTED TO THE TRANS BY A ROD OR CABLE SOMETHING HAS COME LOOSE THERE
Engines problems
You seem to be running RICH ,that's the white smoke. It sounds like you may have a bad MASS AIR FLOW SENSOR. Is the check engine light on? Get some one with a scanner to check the code or codes. GOOD LUCK FIEND.
Not finding what you are looking for?