20 Most Recent
1985 BMW 3 Series - Page 2 Questions & Answers
Ran out of gas 325e bmw turns over great but won't
replace fuel pump. you never run out of gas in a BMW...what's wrong with you? It breaks the fuel pump. It's against the BMW code to sit there on the side of the road waiting for bubba and his towtruck and red can of gas. BMW.....come on. you're supposed to have enough money to buy gas. Anyway, the penalty for going against the bmw code of looking like Jed Clampett on the side of the road for gas is: A broken fuel pump.
I drove my 1985 325 bmw today no problems, parked
No it sounds like a problem with the lock cylinder. Spray some WD40 in the key hole and move the key in and out a few times then try it. If it doesn't work you might have to replace the lock cylinder. Also you could try a different key.
How do i change the
Hi,
Generic Procedure to Change Headlight Bulb on BMW 325 is :-
Disconnect plug.
Turn retaining ring in direction of arrow and remove bulb holder towards rear.
NOTE: If retaining ring is firmly seated, press bulb holder forwards.
Remove bulb from bulb holder.
Let me know, if needed further assistance.
Hope i helped you.
Thanks for using ' Fixya ' and have a nice day!!
I am having problems with
I have a 1985 BMW 735I, the drivers door lock heater is stuck in the on position. How do we get it off??
REPLACE WINDSHIELD WIPER ARM ON 1985 BMW 318I
If you buy a new set of w/blades it will tell you on the back of the box ..
So go into the spare parts in any car spares and look for the box turn it over and read all instructions and you can do it your self in 20 minutes.
Have a goodday RON
Can a weak battery cause a BMW to misfire?
hello, if the vehicle ran with cable off one would ASUME alternator is ok! however, i bad diode in the aletnator would allow it to charge yet have a massive voltage draw as well, almost all of todays parts stores will do a free starting and charging test for you! ......ps a large voltage drop would rob your ignition of voltage causing your miss!.good luck, marty
My 1986 325es cranks but
Here are three possible options, One you should check on the flywheel and make sure there is a tiny block of metal alongthe rim of it generally on the top but it does move, this is the Crank Sensor Pin and if it doesnt have that then theres no way its going to start, Second, you might need to replace the Speed reference sensor, Its the grey sensor on top of the block, because those combined with the crank pin wont let it start, Third along with the speed reference sensor there is a Crank Shaft sensor, the black one next to the speed reference senor, these go bad after around 150K. And another would be to check the Oxygen Sensor; another one you might want to check even though you say it cranks, is check the Ignition coil
If you have any questions
email me, and I can try to help (Had these same problems with more.)
[email protected]
1985 bmw 318i wiper fluid system won't work.
If the pump is working then the nozzles are probably clogged. Either remove and soak in a calcium rust remover or replace.
Also you might want to chace the hose from the tank and make
sure it's not clogged or kinked.
Ignition clicking sound on 1994 BMW 318i
hi... and thanx for asking us
to make sure what is the problem u can turn the head light on and try to start if the head light go off completly and the dash start to loos the light thats mean you cars battery is died,
but if u dont loos any light thats mean the starter .
How do you vent thermostat on 325E (1985)? I
There should be 2 bleeder screws in the system, one on the expansion tank, and one on a thermostat housing. Open both screws all the way. Turn the key to the On postion (but dont start the car). Then turn the heater to max heat, but have the fan set at the lowest setting. Fill the expansion tank til coolant comes out of both bleeder screws with no bubbles. After that close the screws (be very careful not to over tighten them!!). Then completly fill the expansion tank. (dont mind the full mark, if theres air in the system, it will drop the level in the expansion tank) And thats it. Drive the car around then check the level.
1985 325e , cranks but will not start.
Here are two possible options, One you should check on the flywheel and make sure there is a tiny block of metal alongthe rim of it generally on the top but it does move, this is the Crank Sensor Pin and if it doesnt have that then theres no way its going to start, Second, you might need to replace the Speed reference sensor, Its the grey sensor on top of the block, because those combined with the crank pin wont let it start, another one you might want to check even though you say it cranks, is check the Ignition coil
If you have any questions email me, and I can try to help (Had these same problems with more.)
[email protected]
1985 BMW 325 (2) door
Hi Bill,
There is a main relay, however the fuse you're looking for is # 17. Check the window switch if there is power coming to it or not.
12/17/2008 11:05:29 PM •
1985 BMW 3...
•
Answered
on Dec 17, 2008
Not finding what you are looking for?