2001 Oldsmobile Aurora - Answered Questions & Fixed issues


it means your car is overheating

2001 Oldsmobile... | Answered on Jan 18, 2019 | 382 views


You just go to the link I attached I'm sure you will get the solution of your problem
2001 OLDSMOBILE AURORA REPAIR MANUAL

2001 Oldsmobile... | Answered on Feb 15, 2018 | 48 views


Back post wires have broken the door. How long holds the pressure?Maybe is empty.

2001 Oldsmobile... | Answered on Jan 08, 2018 | 115 views


This is a very common problem on GM vehicles. The security system is known to fail. Basically when you insert your key, the system checks for certain OHMS resistance. If the system cannot get the correct signal from the key, it assumes the key is incorrect and goes into SECURITY lockout mode. (prevents hotwiring) This has been happening with GM;s for a very long time. There are ways to bypass this now. Read through this page for info, solutions as well.

http://www.diy-gm-security.com/

2001 Oldsmobile... | Answered on Dec 18, 2017 | 1,309 views


harmonic vibration from the wheel wobbling
could be suspension rubbers , failing bearings or the brake rotor vibrating in the callipers

2001 Oldsmobile... | Answered on Nov 18, 2017 | 112 views


If the injector is clogged it may cause it to run lean & misfire or the cam or crank sensor is causing a misfire. Have an emissions test, proper fuel pressure readings, live computer readings would give u a head start.

2001 Oldsmobile... | Answered on Aug 16, 2017 | 120 views


Power Windows Operation
The vehicle is equipped with power windows controlled by the door modules. Each passenger door power window can be operated, either from a switch built into the driver door switch assembly (DDSA), or from a switch mounted locally on its associated door. The driver door power window can only be operated from the switch built into the DDSA.
If the driver door module (DDM) receives a window switch request from any of the window switches built into the DDSA, the DDM checks the Class 2 serial data to see if conditions are correct (i.e. ignition switch position) to permit window operation to occur. If conditions are correct, the DDM, either supplies power and ground to its associated window motor, or sends a command via the power door serial data line to the passenger door module controlling the window. The passenger door module controlling the window then supplies power and ground to its associated window motor to move the window as requested.
When one of the local window switches mounted on one of the passenger doors is operated, the associated passenger door module examines the request and checks to see if there are any messages from the DDM prohibiting the window operation. If conditions are correct, and no prohibitive messages have been received from the DDM, the associated passenger door module then supplies power and ground to its associated window motor to move the window as requested.


Class 2 data network wires under the carpet behind driver seat. Water shorts out the network an and it won't work .
your looking for tan/white wire's and a connector . This is where the problem is .

2001 Oldsmobile... | Answered on Aug 13, 2017 | 372 views


Check dash fuses and relays. You can find fuse box diagrams in your owners manual. Maybe disconected, loose, or damaged connections. Id take it to the dealer and have the dash looked at.

2001 Oldsmobile... | Answered on Jul 24, 2017 | 314 views


Either the low sensor in the tank is stuck, you have not connected the sensor wire properly or you bought the wrong tank.

2001 Oldsmobile... | Answered on Jun 24, 2017 | 162 views


At the moment, I'm just talking about the front passenger side window. On the hinge side of passenger door, should be wiring harness, probably has protective covering, pull the covering back to expose wire colors. Note the wire colors for battery and ground. Battery is voltage, use a test light, check both orange wires for voltage. You can use to testlight also to check ground, check both grounds. With test light connected to battery voltage, probe the ground wire, both of them, if the lite comes on, at least the ground is good enough to turn on the test light.
passenger window-0pkbgv2qrbrqq4t3zadvwxxw-1-0.jpg

2001 Oldsmobile... | Answered on May 31, 2017 | 411 views


Try you tube !

2001 Oldsmobile... | Answered on Nov 12, 2016 | 137 views


Sounds like you tripped the security system !Try you tube !

2001 Oldsmobile... | Answered on Nov 12, 2016 | 127 views


The security light blinking is the problem, you must get control module scanned for fault codes to diagnose the issue or you can bypass the system if you understand basic electrical systems . Just google bypass passkey system.

2001 Oldsmobile... | Answered on Nov 05, 2016 | 112 views


In the rear fuse block, check the 10A T/SIG HAZ fuse and the 10A IGN-1 fuse. In addition, the turn signal/hazard flasher module and/or the turn signal/multifunction switch may be defective.

2001 Oldsmobile... | Answered on Oct 31, 2016 | 43 views

Not finding what you are looking for?
2001 Oldsmobile Aurora Logo

1,399 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Oldsmobile Experts

Jonah Oneal

Level 3 Expert

14092 Answers

Marvin
Marvin

Level 3 Expert

85223 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22485 Answers

Are you an Oldsmobile Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...