20 Most Recent
2007 Honda Pilot - Page 6 Questions & Answers
2007 Honda Pilot VSA Stays on with the Triangle
A hazard warning could just mean an oxy sensor...I would inspect the vehicle ft. to back ...check brakes and all ...make sure all vacumn hoses and plugs /wires /and brakes are good.Then disconnect the negative battery cable to reset the system....If it comes back on it is probably just an O2 sensor going bad....meaning oxygen sensor...this is an air fuel mixture sensor which is common to go bad on all cars and trucks......No big deal....Hope this helps ....Metalpoet
Took my 07 honda ELement
you don`t say who gave you the code.if you gave them this code not wanting them to check for coeds then you started this problem by not allowing them to check for a code as they would do a more indepth code check then diagnois the problem better.in this case because they did all the work then they would be more inclined to give you a break and correct the problem compared to someone that gives them a code and doesn`t want anythng else done but the code problem putting the owness on the customers request.this is unfortunatly what happens alot because the customer won`t pay to have a job done correctly thinking they will save more money doing it this way.
2003 chevrolet S10 4cyl is
- This code means that Bank one is running to rich. Time to change the Oxygen sensor.
- Follow the exhaust manifold and the first Oxygen sensor you want to replace.
- The sensor will be on the exhaust.
- when the sensor goes bad the engine runs lean.
- Untwist the old Oxygen sensor.
- Remove the connector.
- Install a new one.
- It's just that easy.
- Make sure to use an OEM original 02 sensor.
- You will also want to check the connectors and clean the connector on the MAF sensor on the air intake tube that runs from the air filter housing to the intake.
- If you have any comments please feel free to leave them here.
- Hope this helps and thank you for using FixYa.
Regards,
Tony
Knocking when driving over the
Find another dealer before the warranty runs out. Get the name of the factory Honda regional tech rep from the new dealer, write him and tell him your experience with the first dealer.
How do I remove the
Typically, you need to release interior trim, to gain access to several thumb nuts (can be turned by hand). These nuts retain the entire assembly, and need to be released to access bulbs.
PO172 system too rich bank
Hi,
You need to have the fuel pressure checked, if this is ok you then need to check the valve clearances and once this is done then have the DTC rechecked.
If the P0172 code comes back then you need to check injector pulse timing and then replace the faulty injector.
Let me know if you need more information.
Thanks
Not finding what you are looking for?