20 Most Recent
2007 Dodge Durango Night Runner New Cars Questions & Answers
2007 dodge durango, will turn over won't start, ck
2006 Durango turns over and won't start. After a few try's to get the vehicle started the vehicle will have no power. After sitting for a few minutes the vehicle will start.
Has anyone experienced this?
10/25/2022 10:54:36 PM •
2007 Dodge...
•
Answered
on Oct 25, 2022
I have a 2007 dodge durango....... It as in ac 12
fu8ses don't smell
you are smelling burning plastic
I have to ask
where in the vehicle are you getting 12 Vots AC power as the entire vehicle is 12 volts DC
If yo have some form of inverter attached to the wiring then that system will not be fused to get burning wires
I have air in my braqke lines how do i bleed them
All you need is a helper, with some one inside you go to the right rear wheel have them push the pedal down and keep pushing down until you say other wise, now you open the brake line bleeder it stops flowing then tighten it up. do this several times to push out the air. then go to the driver side rear and repeat this they push it down you open it and so on. be sure to keep refilling the fluid reservoir. do the same at the front lines.no special tools are needed. good luck.,
11/20/2010 11:22:52 PM •
2007 Dodge...
•
Answered
on Nov 20, 2010
I want to know how to replace the oxygen sensor in
Locate the faulty sensor. Disconnect the wiring harness from the plug, use the special socket to remove the old sensor, apply anti seize lubricant to threads of the new sensor, install new sensor first hand tight then again use the special socket to turn it an additional quarter turn, connect the new sensor's plug and clear the fault code in the computer.
Today all 4 brakes locked up and the vehicle
Suspect your booster valve failed open, but not sure the ABS system is working right either. You can test the booster by checking to see if it will do it again in park. If the booster is bad, you'll need to replace it. Then, I'd see if the lights will clear. If not, suspect ABS computer is bad, but I'm not an ABS expert.
Error code 2074 whats the problem
2074 is a manifold pressure/throttle position correlation, high flow vaccum leak. Usually means the engine is getting too much air, and not enough fuel to even out the air/fuel ratio
I hope this helps
My tire pressure monitor went off for a few
If the problem persists stop by a tire shop. Most all of them have a scanner to check the sending units(aka valve stems) and see if one of them is sending a false
signal. Hope this helps.
Not finding what you are looking for?
