20 Most Recent
2008 Dodge Durango Questions & Answers
How to hook up a brake controller for towing
Attached below is diagram illustrating how to hardwire a brake controller into any vehicle. Your Durango should have a blue controller plug that is installed at the factory and that is located under the dash to the left of the steering column. If you have this plug, you would be able to purchase a harness that will mate with that plug and would take a lot of the guess work out.
08 dodge Durango replaced motor but tranny bolts won't screw in but four turns want could I do? Need help asap
Does the bell housing rest tight up against the back of the motor? If so, and the bolts won't go in but four turns, you have real problems. You also haven't said whether or not you replaced the motor with one of the same size and from the same model year. This has been know to have issues. If the bell housing is NOT tight up against the motor then, if it is an auto transmission you may not have the torque converter seated properly on the input shaft. If it is a manual trans, you may not have the input shaft splines lined up to the clutch disc correctly.
Dodge Durango 4 wheel drive won't engage
Four wheel drive vehicles with inside the vehicle four wheel select buttons etc. have plug in four wheel drive control modules, you need to find where yours is located some are under the dash, behind the glove department. others are under the battery box..it can be a DIY job. they are somewhat expensive $ 200 or so..and come in so many modeks..you need to find the exact number of your modual even though you give your vehicle model they vary greatly due to vehicle options...without it your four wheel will not engage....garage cost will be approx $ 400++ so try and find it..Good luck..
Transmission stopped shifting
it could be in limp mode. needs to be scanned for codes. if it feels like its takin off in second gear that is limp mode.
Not finding what you are looking for?