20 Most Recent
2008 Chevrolet Silverado 1500 2WD Questions & Answers
Where is fuel filter
Hello there.
For the past few years more automakers are putting fuel filters on the fuel pumps inside the fuel tank. The fuel tends to wash the surface of the filter to keep them from plugging up.
So no more crawling under and getting that gasoline smell all over you ;).
Hope this answers your question.
I have a serious problem with my chevy silverado
Which sensor? They are replaceable. Do not trust that dealership.either they don't know what they are talking about or they are a rip off. Drive it untill light comes back on and go to a auto parts store. They can pull the codes. Write them down and google the codes and watch some videos on how to do it yourself. Get the part you need and replace it yourself.
Why is there no power to the fuse box for the fuel pump fuse?
Takes an electrical diagram, volt meter, and a bit of time to figure out. Check other fuses that should have voltage with the key on. If there's no power to them, then it would be the ignition switch. If there is, then a broke wire would be the cause.
Why is the fuel pump fuse not getting any power feed?
The fuse gets it's power from the fuel pump relay , located in the under hood fuse/relay box. An the ECM- engine computer energize the relay . This does not mean the relay is bad ,Because you have no B+ at the fuse. The thing to do is test for B+ voltage at pins 30 an 86 while cranking the engine . The relay position will be given on the under side of the lid for fuse/relay box. Pull the relay an look at the bottom ,pins side or terminals ,what ever you would call them . Each terminal is marked with a number 30,87, 85 ,86 . The ECM will only energize the relay when it receives a message from the BCM - body control module , with no anti-theft system problems . Do you have a pad lock an car symbol lit on the instrument cluster ?
Where is horn located on 2008 silverado
Look between the grille and the radiator on the center post for the radiator support, there should be one and then another under the hood on the drivers side.
Turn signal location 2008 chev. silverdo
Not sure what you are asking here but the turn signal assembly where you move the arm to turn left or right is in the steering column. The power unit should be attached to the fuse panel it will be the large round alum. looking relay. Hope this helps.
How do i remove the back seat in my 2008 chevy 4 door truck
don't know this vehicle specifically but on many cars the rear seat base is held on with a clip on each side. Grab the seat at the front bottom, push back/down, then pull up. Same for other side. Once the base is out there is often a bolt on each side holding the seat back on. Take out the bolt and lift the seat back up.
Lock
If you have a lock not working it is more than likely the complete door latch which contains the door lock actuator. Sold as a unit. Common problem for the door locks to become inoperative.
Remove heater ac air posion moter on 2008 chev pickup
I think the part is called the blend door actuator.
1.You have to remove the plastic cover on passenger side. Motor is located over the transmission hump.
2. Remove wiring harness plug.
3. Remove 3 hex head screws.
You need a small 1/4 socket set.
Not finding what you are looking for?