20 Most Recent
2008 Ford F 250 Super Duty 4WD Questions & Answers
I have a 2001 f350
CODE PO720 - OUTPUT SPEED SENSOR MALFUNCTION / CODE PO732 - INCORRECT GEAR RATIO SECOND GEAR / CODE PO781 - FIRST TO SECOND SHIFT MALFUNCTION / CODE POP1247 - TURBOCHARGER BOOST PRESSURE LOW CONDITION. COULD NOT FIND CODE PO1316. LOOK ALL PROBLEMS COULD BECAUSED BY CODE PO720 FAULTY OUTPUT SPEED SENSOR IT CONTROLS TRANSMISSION SHIFTS.
2008 ford f-250 reset oil change readout
To reset the oil light follow these steps:
1. Insert the key and turn it to ON position
2. Press select and reset button until you get the message that hold reset to get to the setup menu
3. Then, get to the hold life percentage menu
4. Now, hold the button again, and the percentage will reach a 100%
5. Turn off the car, and then crank up the engine, the oil light should turn off.
I have a 2008 ford
Hi
Loose belt - lose fan belt, loose power steering belt are the main cause for the high pitch whine in car. The belts tend to stretch out over time and loosen; the turning engine "slips" the belt upon acceleration of the engine. Starting up goes from a dead stop to fast running - leading to more slippage. Also a defective starter drive or a chipped tooth on ring gear
Manually rotate engine (socket on crankshaft). Make sure vehicle is in neutral is standard and then try to start if vehicle starts probably a chipped tooth if not probably a bad starter drive .
Let us know if you have something more to ask else please accept the solution.
Thanks for contacting fixya.com
The trailer electric brake controller does not
i have a 2008 ford f250. when i pull my travel trailer the instrument gauge says trailer disconnected and it also says trailer wiring malfunction. then my trailer brake systems turns red and blinks. i took my ford to the dealer they said the truck is fine it is the trailer. than I took my trailer in to get looked at they said the trailer is ok and that 2008 fords have problems with the stock electric brake system what do i do
Ford 6.4 diesel no power showing bad part filter, what do i do ?
Ensure nothing is strangling the intake or exhaust and then ensure nothing is limiting the free flow of a good supply of clean air-free fuel.
If nothing is found it will be time to delve into the engine conditions and settings, the performance of the injection system and any electronic controls.
Oil can light stays on
Run a Scan on it first but also check the Oil Pressure Sending Unit and the actual Oil Pressure with a Mechanical Gauge. You may have a bad oil pump.
2008 f250 super duty 6.8 deilsel
sounds like an egr valve problem, pull the egr valve out of the intake (2 8mm bolts and pry out with a "ladyslipper" style pry bar, it it is covered with thick soot then this is probably your problem, this problem will often not trigger a code
Find the fuse for the horn of a 2008 Ford F250?
Fuse/Relay Location: 24
Fuse Amp Rating: 20A
Passenger Compartment Fuse Panel Description: Horn Relay Feed
http://www.fordservicecontent.com/Ford_Content/catalog/owner_guides/08f23og1e.pdf
Not finding what you are looking for?