20 Most Recent 2007 Chevrolet Malibu SS Sedan New Cars Questions & Answers

The reason you cannot locate a fluid reservoir is because there is none. Your car has an electric power steering. If the problem continues to persist, you may have to replace the power steering pump.

I would need to rid along and hear the noise to be of any useful help.

There are no wires you can touch to program key fob's , Dealer only ! Need a factory scan tool ! This procedure will erase all keyless entry transmitters from memory. Install a scan tool. Turn ON the ignition with the engine OFF. With the scan tool, select Body. Select Remote Control Door Lock Receiver (RCDLR). Select Module Setup. Select Program Key Fobs. Select Invalidate All. Follow the scan tool on screen instructions.

This is an only code you get?

Just trying to logically get through this... Stabilitrak is the electronic stability control system, which is the evolution of ABS. So, an ABS failure would also mean that stabilitrak wouldn't work. Could there be an electrical problem, like two wires shorted on each other? It's like one wire overheated and burned through, then burned through an adjacent wire a couple of minutes later... for more software help visit https://cbrtechsolutions.net

THERE IS A BLEEDER NUT ON EACH CALIPER,ONE PERSON BLEEDS AND THE OTHER PUMPS THE BRAKE PEDAL

fallow t0p rad hose to block should be right under housing

There are several things in the transmission that could cause this. Bad converter, bad pump, bad seals. Just to name a few. If you have the CVT transmission, then there are other problems that could exist.

Check fuse in fuse left dash cover, cigaret ligther defective

the ground in my headlight connector got hot ,melted, and the headlight quit, a couple 3M disconnects fixed it right up If you need further help, I’m available over the phone at https://www.6ya.com/expert/david_4c166ba81493f541