Top 20 2007 Chevrolet Equinox LS New Cars Questions & Answers

Reconnect the plug on the Coolant Temperature Sensor. He didn't reconnect it. https://www.google.com/search?q=2007+chevy+equinox+coolant+temperature+sensor+location .

Question edited for year make model. Question moved to sub category. It is a known fault on that model. https://www.google.com/search?q=2007+chevy+equinox+gauges+not+working ..

Are you sure it is the pump and not the switch?

First have the battery tested, it is a free service of any auto parts store like Autozone and others.

Do yourself a favor an take it to a qualified repair shop an have diagnostic's done . Could be any number of thing's . we'd only be guessing .

here is a copy of your owners manual the information is on page 391-396 https://cdn.dealereprocess.net/cdn/servicemanuals/chevrolet/2007-equinox.pdf

usually when there is no gas in the ac system it will not come on, check if you have gas in the system, if not you might have a leek that needs to be solved before recharging the system with gas

Take it back to the dealership! Sounds like wrong fluid was used or damage was caused by fill procedure. Gm transmissions are also electronic and components such as solenoids could be failing. Never Never change or flush GM transmissions as early as 70,000 miles if it is normal use. You are asking for trouble. Under normal use they are sealed and can go for 100,000 mile under normal operation

If this is by chance a Equinox then you have a cracked fuel line and if you live in the south you will need to take it into dealership because that fuel system has a recall on it. Hope this helps

The PCM (computer) is limiting the throttle because something is wrong with your suspension , steering or braking system. Have you had brakes worked on, changed tire sizes etc? The stabilitrack system gets feedback from sensors in each wheel> Such as speed, rotation angle etc and makes adjustments to stabilize the vehicle. If the sensors are not working properly or the braking is not balanced, the computer will throttle down the vehicle to prevent what it thinks is the beginning of a skid.

A vehicle will not stay running unless it has a good ground field and if the battery has died. You may not be able to be able get it to run. Try a jump. If it starts and runs, un-hook the ground and see if it stays running. Good luck.

Any tune up issue could be bad catalytic

you can get on google and put 2007 EQUINOX CODE P00xx, P00yy and it should give you some info. Some topic may be to explain your code and some may be other people and what they did to fix it. Need to let you know a code does not have the same fix all the time. The code may indicate fuel system. It could be a fuse, relay, injectors, fuel pump or wiring. I like to look at what other people have done to fix the problem and start with the cheep fix. If you know your car is 2.0L engine you can put 2.0L in the search. Some codes are more specific to a specific part and others may have a few separate parts you have to look at.

I haven't heard about problems like that other than in a flood damaged vehicle.Did you buy it new? To check for a battery drain yourself,disconnect the battery large cable and place a 12 volt test light between the cable and the battery positive.If you see a bright light on the test light you do have a vehicle drain,if it's dim don't worry about it.Now,if the light is bright pull one fuse at a time until the light goes dim,this will be the circuit draining and you can now trouble shoot that circuit.Don't cause a bright light by opening a door or turning on the key.DO NOT TRY AND START THE VEHICLE while the test light is hooked up.

Ouch! Sounds like you broke the timing belt.

Vent for what? Differential? Fuel system? Automatic trans? Other?

More than likely the plastic clips that hold the linkage together have either fallen off or broken. You'll have to remove the door panel to get access to the linkage. Most places like autozone carry the plastic clips but you may want to go directly to the dealer and buy them so you know they'll fit.

Haven't worked on yours, but all the newer GM's have two bolts in the back part of the seat, at the floor board. Push the seat forward, remove the covers , if any, remove the bolts, tilt the seat up and pull back on it. This should get it out.

There are many possible factors including incorrect parts, defective rotor - pads - actuator, improperly bled front brake line, improper maintenance practice during last service. Best to take the vehicle to a qualified mechanic as soon as possible for your and others safety. Tow if you feel it is unsafe to drive that distance. Best of luck.