Top 20
2008 Ford Mustang Questions & Answers
Would a bad serpentine belt on my 2008 Mustang cause my heater to blow cold air sometimes
if the serpentine belt is original then have it changed as it is probably hard and not gripping properly
it is a reason that the ac compressor will not be at full efficiency , just like power steering not as good as it should be and alternator not charging properly
the inspection of the belt is in the grooved section and it shows minute cracks in the groove ribs then it is overdue for a change
7/26/2017 10:45:03 PM •
2008 Ford...
•
180 views • 0 helpful votes
Why is my blower only blowing out of my defrost in my 2008 mustang
The A/C and heat is regulated by a vacuum activated door under the dash called the actuator door. There may be a vacuum leak causing the door not to work. Check under the hood on the driver's side. There is a vacuum manifold that provides vacuum for several different functions inside and underneath the hood. One will be marked A/C and have an arrow leading to the proper hose. Check all the hoses for leaks because if one leaks it will affect all the vacuum for all the other functions. Vacuum leak may be the problem.
4/10/2015 2:15:12 PM •
2008 Ford...
•
104 views • 0 helpful votes
2008 mustang and wipers work fine but washer fluid wont work?
The fluid could be frozen in the hoses or the pump is broken. If you drive the car for awhile, the hoses will thaw out and the washers will work. Try getting fluid good to -20F. This fluid will be good for most areas in the US.
Replace the pump if you turn on the switch and hear no sound from the engine bay. Have someone standing close by for this test.
1/9/2015 9:27:14 PM •
2008 Ford...
•
179 views • 1 helpful votes
Sealed transmission
If it is a manual transmission there won't be a dipstick for it . You will need to park on a level surface and remove the fillplug from the transmission.insert your index finger up to the first knucle into the hole. If you can touch the oil the level is fine, if notyou can add some till you do or it starts running out the hole and reinstall plug.If you can touch the oil
11/12/2012 5:28:36 PM •
2008 Ford...
•
125 views • 0 helpful votes
My engine is shaking badly
You likely have a misfire. You will have to scan the code to be sure. You might have something simple as a clogged injector or a dead spark plug. If you don't have an OBDII scanner, AutoZone will scan it for free but you definitely don't want to drive far until you know what's wrong with it. Chances are you should have it towed to a professional mechanic if you're unable to scan it yourself.
7/24/2012 3:01:15 PM •
2008 Ford...
•
301 views • 0 helpful votes
Not finding what you are looking for?