2008 Subaru Impreza Wrx - Answered Questions & Fixed issues
I AM ASKING FOR APPLICATION FORM SO THAT I CAN APPLY
Anon, no application required at this site, this is fixya web site.
Check the attached links,fixya info. Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
About Us FixYa
Contact Customer Support Fixya
Fixya community of real people easy fixes useful advice
8/20/2016 2:04:36 PM •
2008 Subaru...
•
Answered
on Aug 20, 2016
•
41 views
How to change engine oil in subaru wrx
First off before you do anything locate and know where your oil pan is and your oil filter. Your pan will be accessed from under the car and will have about a 9/16 bolt on it. That is your oil pan drain. Find your filter which will be most likely on the front right of the engine. Get a pan under the oil pan plug, take off your oil cap in the engine, and unscrew the drain plug. As it is draining take off your oil filter with a filter wrench. You will most likely want something to set the filter in when you loosen it (it is full so keep it upright as possible) Let it drain until all is out, replace the filter, put the plug back in and fill with the recommended amount of oil. Turn it on for about 15 seconds and then off. Check for leaks at the plug and filter and tighten if needed. The filter does not get "cranked down". Don't forget to put your cap back on the top side and you are done. Before you close the hood check to make sure the oil level is in operating range marked on the stick.
7/17/2014 8:15:38 PM •
2008 Subaru...
•
Answered
on Jul 17, 2014
•
76 views
Starter grinding flywheel
If you had a flywheel replaced it is possible that it is not reinstalled properly. Check for engine vibration at idle . Check that the starter is in correctly. IT appears that the starter pinion is not meshing correctly with the ring gear and that is your noise . It goes after starting because the pinion disengages from the ring gear. The problem is a misalignment between the pin ion and the flywheel ring gear ( nothing at all about polished gears ). IT is all in the installation of the flywheel -starter and gear box.
4/2/2014 10:02:12 AM •
2008 Subaru...
•
Answered
on Apr 02, 2014
•
411 views
My 2008 WRX has 22K. The clutch peddle started
Subaru makes/sells a good product. Too bad you've had issues with the clutch in/of your WRX. Since you have 25 years of experience driving manual transmission car(s) you should understand that the problem can not be pinpointed without taking the component apart. Your vehicle is under the manufacturer warranty so Subaru should repair/replace the defective clutch. After the WRX is fixored sell it and buy another VW......Peace
12/1/2012 8:04:47 PM •
2008 Subaru...
•
Answered
on Dec 01, 2012
•
550 views
Engine light on with flashing cruise control
This happened to me when I forgot to change my engine oil when it was due for an oil change. After I changed my engine oil, it took about 200 miles for the Engine light and flashing cruise control to turn off.
9/5/2012 8:39:15 AM •
2008 Subaru...
•
Answered
on Sep 05, 2012
•
714 views
Striped the nut on the
Hello,
Subaru always states in their service manuals to replace all self locking nuts with new hardware, never reuse old nuts.
Tightening torque for the 3 nuts that fasten the strut to the body: 20 N-m (14.5 ft-lb)
The main strut rod nut torque spec is: 55 N-m (40.6 ft lbs)
8/1/2011 7:28:26 AM •
2008 Subaru...
•
Answered
on Aug 01, 2011
•
385 views
I have a 2008 Subaru
hi i have had this problem before it turned out to be the interior heater radiator coil under the dash it had a hole in it causing water to pool in the car and causing the heater to **** in air causing the heater to sound like you mentioned i would give that a check first, the radiator is under the dash either on the passenger side or near the middle as some models changed position
4/24/2011 10:29:52 AM •
2008 Subaru...
•
Answered
on Apr 24, 2011
•
372 views
Not finding what you are looking for?